PORTABLE DVD PLAYER

V11M11_IM_EN_10282009

GETTING STARTED

Location of Controls on the Remote Control

jWIN

1.

A-B REPEAT button

10.

DISPLAY button

2.

PROG/REPEAT button

11. ANGLE / AUDIO button

3.

0-9 Number buttons

12.

TITLE / SUBTITLE button

4.

SETUP button

13. MENU / ZOOM button

5.

GOTO button

14.

STOP / SLOW button

6.

FWD button

15.

Direction buttons ()

7.

NEXT button

16.

REV button

8.

PREV button

17.

ENTER button

9.

SOURCE button

18.

PLAY / PAUSE button

Note:

-Long press 2, 11, 12, 13, 14 will activate the functions marked lower on these buttons (PROG, ANGLE, TITLE, MENU, SLOW).

-Short press 2, 11, 12, 13, 14 will activate functions marked higher on these buttons (REPEAT, AUDIO, SUBTITLE, ZOOM, STOP).

6

PORTABLE DVD PLAYER

V11M11_IM_EN_10282009

GETTING STARTED

Changing the Remote Control Batteries

Place the remote control on an even surface and insert the supplied button cell into the remote control as follows.

1.Push the button towards left

2.Pull the battery loader out

3.Insert the battery into the receptacle Make sure The polarity matches the marks inside the component.

4.Insert the receptacle into the remote control.

Cell data

Battery type: 1x CR2025, 3 V

Service life: approximately 1 year (for normal use and room temperature)

Using Of Remote Control

Point the remote control towards the main unit when operating. The remote control works best at a distance less than 5 m and at an angle of up to 30º to the front of the unit. No obstacles may stand in the way between remote control and infrared sensor and do not place the remote control in direct sunlight. If the remote control unit fails to work even when it is operated near the player, replace the battery.

Notes on batteries

If the remote control is not used for a long period of time, please remove the battery from the compartment.

Do not heat batteries or dispose of them in fires. Do not dismantle, deform or modify batteries.

Connecting the DVD player

·The DVD player, the television set and any other electric devices to be connected to the DVD player must be switched off and disconnected from the mains. ·Observe the color coding when connecting audio and video cables.

1 .Connecting to a television set Audio/video Connectors Using the audio/video cable, connect the DVD player to the A/V inputs of the television set as shown in the illustration.

7

www.jWIN.com

www.jWIN.com

Page 4
Image 4
Jwin JD-VD768 Location of Controls on the Remote Control, Connecting the DVD player, Changing the Remote Control Batteries