K-Tec HP3A instruction manual Blender Motor, Blender JAR Assembly, Installation

SECTION 3

Blender OVERVIEW

(Refer to Figures 1 and 2)

3.1 BLENDER MOTOR

•Motor Cover: Houses the power unit in a durable, easy-to-clean polycarbonate.

•Touch Pad: Consists of six buttons that contain pre-programmed settings for selective blender control, a pulse button, and two speed control buttons.

•LCD Information Center: will indicate status of unit as well as overload or over-temperature conditions.

•Power Unit: This unit is located within the blender motor and contains the machinery that runs the blender.

•Power Switch: Located on the back lower-right corner of the power unit.

3.2 BLENDER JAR ASSEMBLY

The blender jar assembly consists of the blender jar, blade assembly, and lid.

•Jar: Made from polycarbonate to provide maximum efficiency and clear visibility of blender performance.

•Blade Assembly: Stainless steel designed to provide fast consistent blending

SECTION 4

INSTALLATION

We recommend that surge protection be placed between the receptacle and the blender motor.

1.Place blender on a flat, clean and dry surface.

2.Make sure a plug outlet is available within four feet of the blender motor.

3.Ensure that the unit is turned off before plugging it into a separate 120-volt receptacle.

4.Ensure that blender vents are unobstructed to allow proper cooling during use.

HP-4