Operating Instructions
Before First Use
Remove any promotional material from the vacuum cleaner.
When unpacking the vacuum cleaner check to see you have received all the required components, such as the hose and other accessories before discarding the packaging.
To Operate the
Vacuum Cleaner
Locate the crush proof hose and push the connection point into the hose inlet connection on the front side of the vacuum, until a “click” sound
is heard.
Connect the wide end of the metal wand to the hose end, and push together firmly.
Fig. 1
Fit the floor tool to the narrow end of the wand and push together firmly.
Fig. 2
Fully extend the power cord by pulling the power plug out from the rear of the vacuum, until the yellow tape on the cord is showing.
NOTE: Ensure that you do not over extend the power cord
–do not extend past the red warning tape on the cord.
Plug into a 230/240V power point and switch the power on at the power point.
To commence vacuuming, push down on the on/off button on the top of the vacuum cleaner.
When vacuuming is complete, push down on the ‘on/off’ button to switch off. Turn the power off at the outlet and then remove the power cord from the power outlet. When removing the plug from the power outlet, grasp the plug not the cord.
To retract the cord push down on the
‘cord rewind’ button on top of the vacuum cleaner.
IMPORTANT: Hold the plug end and guide the cord into the vacuum during retraction to prevent it from striking you or the vacuum.
CAUTION: Always ensure that the dust container and the motor protection filter are correctly fitted. Never operate without the dust container or filters in place.
7
23/08/11 10:12 AM |