Using Your Ceramic Tower Heater
Before First Use
Remove any promotional material or packaging from the heater.
Unwind the cord to its full length and place the heater on a firm, level surface in a stable upright position. Visually inspect the air inlet and outlets to ensure there are no blockages.
When unpacking the heater, check to see you have received the remote control, before discarding the packaging.
Turning Your Heater On
Plug the cord into a 230V or 240V power point and switch on.
NOTE: To avoid an electrical circuit overload, it is recommended that no other appliances are plugged into the same circuit as your heater, when it is in use.
Turn the heater on by switching the Power ON/OFF switch located on the back panel of the heater, to the ‘ON’ position. An audible beep will sound. The heater is now in standby mode.
Using The Remote Control
Your heater may be operated using either the control panel or the remote control.
The remote control uses 2 x AAA batteries. To access the battery compartment, simply remove the cover at the rear of the remote control.
To operate, ensure that you point
the remote control at the heater. An audible beep will sound with the press of each button.
Setting the Heating Mode
To activate the heater, press the ON/OFF button. The heater will start operating on the LOW heat setting (1200 watts) and the LOW LED will illuminate. The ON/OFF LED will also illuminate.
Use the MODE button to select the desired heat setting. The MODE button allows you to select from two heat settings.
HIGH – High heat setting (2000 watts) LOW – Low heat setting (1200 watts)
Turn the heater off by switching the Power ON/OFF switch located at the back panel of the heater, to the ‘OFF’ position.
NOTE: This heater features a
8
KCE640_IB_FA.indd 8 | 16/10/09 10:50 AM |