Kambrook KHC10B manual Maintaining Your Kambrook Hair Clipper Cleaning, Oiling

Short Cuts to Perfect Flat Tops, Crew Cuts

C-1 C-2 C-3

C-4

1.Always cut from the back of the neck to the crown, using the longest attachment comb. Holding it flat against the head, slowly move the hair clipper up through the hair. (Diagram C-1)

2.Use the same technique for the sides, cutting from the bottom to the upper side of the head.

3.From the front to the crown, cut the hair against the direction in which it grows.Then even it up with the sides. (Diagram C-2)

4.For a flat top, use a normal flat comb and cut hair on top of the head over it.

5.To taper hair down to the neckline, use closer cutting attachment combs. Comb hair and check for uneven spots and outline sideburns and neckline. (Diagram C-3)

6.If a short tapered cut on the sides and back is desired, follow the diagram below and change attachments as illustrated.

(Diagram C-4)

Maintaining Your Kambrook Hair Clipper

Cleaning

After you have finished using your hair clipper rapidly move the adjustable lever up and down a couple of times while the hair clipper is still running, to remove any hair that may be caught in between the blades.Then switch off the appliance and power outlet.Then unplug your hair clipper and clean the blades with the brush supplied.

Oiling

To maintain the hair clipper in peak condition, the blades should be regularly oiled before, during and after every haircut. A substitute/replacement for the clipper oil supplied in the kit is household sewing machine oil.

NOTE: Do not use hair oil, grease, oil mixed with kerosene or solvent, as the solvent will evaporate and leave the thick oil, which may slow down the blade motion.

To oil the blades, gently squeeze a few drops of oil between the blade teeth and turn the clipper on, checking that the clipper is running smoothly.

If the blades are dulled and have stopped cutting, replace them with new blades from your nearest Kambrook service centre.

6