Kambrook KVC12 Crevice and brush tool accessories, Using the Park Tool feature, Model KVC11 only

Crevice and brush tool accessories

The crevice tool is ideal for vacuuming hard to reach places such as the edges along skirting boards.

The brush tool can be used to vacuum delicate surfaces and areas such as shelves and venetian blinds.

For models with Variable Power Control, set between Minimum and Medium power when using the tool accessories.

For models without Variable Power Control, slide the Fingertip Suction Control cover (located on the hose handle) to the open position.

Models KVC12/KVC15 and KVC16

Separate crevice and brush tools are located inside the on-board tool storage compartment.The opening for this compartment is located directly below the hose connection inlet.To open place a finger inside the thumb groove and pull the compartment lid upwards.

Model KVC11 only

The crevice tool with detachable brush attachment can be stored on the wand attachment for easy access and storage.

To use the crevice tool, detach the brush attachment from the

top to reveal the crevice tool.When the brush attachment is required, push the back onto the top of the crevice tool until it is firmly in place.

Turn off the vacuum when changing any attachments.

Using the Park Tool feature

The vacuum features a 2-way park tool feature, which allows you to easily store the wands with the floor tool directly on the vacuum body.This is ideal when storing the vacuum or if you need to temporarily ‘park’ the vacuum while you are cleaning.

To park the vacuum in the upright (storage) position

The park tool attachment hook, for upright storage is located on the lower wand.

With the vacuum switched off

and unplugged from the power point, place the vacuum on its end (in an upright position), insert the park tool hook into the park tool receptacle on the underside of the vacuum body (located to the upper right of the front

wheel).

Note:The floor tool should be attached and in contact with the floor to give stability, if correctly assembled.

To park the vacuum

in the horizontal position

The park tool attachment hook, to park the vacuum in the horizontal position, is located on the floor tool head (on the wand connection point).

With the vacuum on the floor in a horizontal position, hold the floor tool head facing outwards

and insert the park tool hook into the park tool receptacle located at the rear of the unit.

6