Kambrook KVC12 manual Replacing dustbag and filters, Dust bag indicator and changing the dust bag

Models: KVC12

1 12
Download 12 pages 6.37 Kb
Page 7
Image 7
Replacing dustbag and filters
(Fig. 1/2-A)

Replacing dustbag and filters

Dust bag indicator and changing the dust bag

The dust bag should be changed when full. The dust bag indicator window will gradually turn red as the bag fills up and when the dust bag indicator displays ‘red’ it is time to change the dust bag.

Always switch appliance to off, then switch off at the power outlet, then unplug the appliance prior to replacing dust bags or filters.

To remove the dust bag, have the unit down on its wheels, remove the crush proof hose and then lift the ‘Dust bag compartment lid release lever’ and pull the top cover back

To remove the bag, grasp the top of dust bag and pull out (Fig. 2-B), and dispose in a rubbish bin.

Fig. 1. KVC11

A

Dust bag holder

BDust bag indicator and changing the dust bag

Filter holder

Fig. 2. KVC12/15/16

A Replacing filters

Filter holder

B

Dust bag holder Motor protection filter

To place a new dust bag, take a fresh dust bag and with the arrow (printed on the cardboard section of the dust bag) pointing down, slide the cardboard down into the dust bag holder, until it comes in contact with the bottom of the holder.

HINT: once the bag is inserted ‘puff-out’ the bag as much as possible to ensure the full capacity of the bag can be taken up. When vacuuming fine dust particles, the fine dust particles can clog the pores of the dust bag and the dust bag indicator will indicate full. If this happens the bag could appear relatively empty, however the bag will still need to be changed to avoid strain on the motor.

NOTE:The bag compartment lid may not close if the bag is not correctly fitted.

IMPORTANT: DO NOT USE THE UNIT WITH OUT A DUST BAG IN PLACE

Replacing filters

Filters must be cleaned from time to time to remove the fine dust particles that have been collected.This can be done by shaking them, however after approximately 5 dustbag changes the filters should be replaced.

Motor protection filter

The motor protection filter must always be in place when operating the vacuum otherwise damage to the motor may occur.To replace the motor protection filter - Remove the dustbag or pull the bag forward.The motor protection filter is located at the rear, right hand side of this

KVC12/15/16

Filter holder

Removable foam filter

7

Page 7
Image 7
Kambrook KVC12 manual Replacing dustbag and filters, Dust bag indicator and changing the dust bag, Replacing filters