HD3000 Manual 9/20/02 5:28 PM Page 4
ASSEMBLY INSTRUCTIONS
OPERATING INSTRUCTIONS
Step 1 Attach the handle to the frame of the pressure washer. Align holes, insert bolts, and tighten with knobs.
Step 2 Attach the gun/hose storage handle.
Step 3 Attach the reel to the handle. Align holes, insert bolts, and tighten with nuts.
Step 1 Check oil level. Oil level should be level with the bottom of the oil filler neck. Be sure the machine is level when checking the oil level. (Refer to the engine’s operating manual for seasonal grades.)
We recommend that the oil be changed after the first 5 hours of use, then once every 50 hours.
Note: Improper oil levels will cause low oil sensor to shut off engine.
Step 2
Fill gas tank with unleaded gasoline.
Do not use leaded gasoline.
Step 3
Connect garden hose to the cold water source and turn water on completely.
Never use hot water.
3
Step 4 Place the quick connect nozzles in the nozzle holder.
Step 7 Release the collar and push the nozzle until the collar clicks. Pull the nozzle to make sure it is seated properly.
Step 5 Attach the wand to the spray gun.
Step 8 Attach the high pressure hose to the spray gun.
Step 6 Pull the spring- loaded collar of the wand back to insert your choice of quick connect nozzle.
Step 9 Connect the high pressure hose to the unit’s high pressure outlet.
Step 4 Trigger the gun to eliminate trapped air, wait for a steady flow of water to emerge from the spray nozzle.
Step 5 Slide the choke lever to the left to the “CLOSED” position (on a warm engine, leave the choke lever in the open position).
4 |
Step 6 Slide the fuel valve to the “ON” position. Slide the throttle lever left about 1/3 of the way toward the fast position.
Step 10 Connect the garden hose to unit’s water inlet.
Important!
Do not run the engine with a high or low oil level as this can cause engine damage. If you have further questions regarding the engine, please refer to the engine’s operating manual included with the unit.
Step 7 Turn the engine | Step 8 Pull the starter | Step 9 Adjust pressure |
switch to the “ON” position. | handle. If the engine fails to | control to desired setting. |
| start after 3 pulls, squeeze |
|
| the trigger gun to release |
|
| pressure, and repeat step. |
|
After the engine is warm and running smoothly, slide the choke lever to the right (open) and throttle to the left (fast).
