Karcher HD 3000 CLEANING TIPS - continued, Troubleshooting, Optional Cleaning Accessories, Cause

Models: HD 3000

1 21
Download 21 pages 19 Kb
Page 6
Image 6
CLEANING TIPS – continued

HD3000 Manual 9/20/02 5:28 PM Page 10

CLEANING TIPS – continued

Barbeque Grills, Outdoor

Power Equipment &

Gardening Tools

(with or without detergent)

Pre-rinse cleaning surface with fresh water. If using Kärcher All Purpose Cleaner or Degreaser, place detergent suction tube directly into cleaning solution and apply detergent at low pressure. Allow Kärcher detergent to remain on surface 1-3 minutes. Do not allow detergent to dry on surface. Rinse at high pressure keeping the spray nozzle approximately 3-6 inches from the cleaning surface. For removing extremely stubborn dirt, it may be necessary to move the spray nozzle even closer to the surface for greater dirt cutting action. To remove caked on mud from garbage cans, lawn mower blades, wheelbarrows or other non-sensitive metal surfaces, you may want to use the Kärcher Dirtblaster® Nozzle.

Caution: Do not use Dirtblaster® spray

9nozzle on cloth, plastic or other sensitive surfaces as it may cause damage.

Patio & Lawn Furniture

(with or without detergent)

Pre-rinse furniture and surrounding area with fresh water. If using Kärcher All Purpose Cleaner, place detergent suction tube direct- ly into cleaning solution and apply to surface at low pressure. Allow Kärcher All Purpose Cleaner to remain on surface 1-3 minutes. Do not allow detergent to dry on surface. Rinse at high pressure in a sweeping motion keeping the spray nozzle approximately 3-6 inches from the cleaning surface. For best results, clean from top to bottom and from left to right.

Caution: Do not use Dirtblaster® nozzle on patio or lawn furniture as it may cause damage.

Recommendations

Before cleaning any surface an inconspic- uous area should be cleaned to test spray pattern and distance for maximum clean- ing results.

If painted surfaces are pealing or chipping, use extreme caution as pressure washer may remove the loose paint from the surface.

TROUBLESHOOTING

Symptom

Cause

Solution

 

 

 

 

 

 

Engine will not start.

No gasoline.

Fill gas tank.

 

 

 

 

 

 

 

Low oil level sensor activated.

Add oil.

 

 

 

 

 

 

 

Fuel valve is in “OFF” position.

Slide the fuel valve lever to “ON” position.

 

 

 

 

 

 

 

Engine throttle is not in

Slide the throttle left 1/3 of the way

 

 

correct position.

to the fast position.

 

 

 

Choke is not in correct position. Slide choke lever left to “CLOSED” position.

 

 

 

 

 

 

 

Pressure built up in the

Squeeze the trigger to release

 

 

high pressure washer.

the pressure.

 

 

 

 

 

 

 

Engine switch in “OFF” position.

Turn engine switch “ON”.

 

 

 

 

 

 

Unit does not reach

Diameter of garden hose

Replace with a 3/4 inch

 

high pressure.

is too small.

garden hose.

 

 

 

 

 

 

 

Water supply is restricted.

Check garden hose for kinks,

 

 

 

leaks and blockage.

 

 

 

 

 

 

 

Not enough inlet water supply.

Open water source full force.

 

 

10

 

 

 

 

 

Water inlet filter is clogged.

Remove filter and rinse out

 

 

 

in warm water.

 

 

 

 

 

 

 

Pump pressure control is in

Turn pump pressure control to high

 

 

low pressure position.

pressure position.

 

 

 

 

 

 

 

Black detergent nozzle

Remove black detergent nozzle and

 

 

is attached.

attach a high pressure nozzle.

 

OPTIONAL CLEANING ACCESSORIES

Optional cleaning accessories are available to further enhance your cleaning capabilities. See accessories order form for product descriptions and ordering instructions.

• Dirtblaster® nozzle

• Hose Reel

• Extension Wand 80”

• Pipe Drain Cleaner

• Rotating Wash Brush

• Extension Hose 30’

• Sand Blasting Attachment

• Detergent Tray

USA: 1-800-537-4129

www.karcher-usa.com

CAN: 1-800-465-4980

www.karcher.ca

Output pressure varies Not enough inlet water supply.

Turn water on full force. Check garden

high and low.

hose for kinks, leaks or blockage.

 

 

 

 

Pump is sucking air.

Check that hoses and fittings are air

 

 

tight. Turn off machine and purge

 

 

pump by squeezing trigger gun until

 

 

a steady flow of water emerges

 

 

through the nozzle.

 

Water inlet filter is clogged.

Remove filter and rinse out

 

 

in warm water.

 

 

 

 

Discharge nozzle

Blow out or remove debris

 

is obstructed.

with a fine needle.

 

 

 

 

Calcified gun, hose

Run distilled vinegar through

 

or spray wand.

detergent suction tube.

Page 6
Image 6
Karcher HD 3000 CLEANING TIPS - continued, Troubleshooting, Optional Cleaning Accessories, with or without detergent