IMPORTANT PRECAUTIONS – continued
Water Supply
(Cold Water Only)
•Water hose must be at least 3/4 inch in diameter.
•Flow rate of water supply must not fall below 2.5 GPM (gallons per minute).
•Flow rate can be determined by running the water for one minute into an empty
•The water supply temperature must not exceed 104°F/40°C.
•Never use the pressure washer to draw in water contaminated with solvents, e.g. paint thinners, gasoline, oil, etc.
•Always prevent debris from being drawn into the unit by using a clean water source.
ASSEMBLY INSTRUCTIONS
You will need a standard screw driver OR a Torx
3
Step 1 Align holes on adapter brackets with the posts on pressure washer as shown. Tighten the four screws.
Step 2 Press down to lock handle onto top of adapter brackets.
Step 3 Slide the spray wand extension into the gun. Turn the wand collar onto the gun threads until tight.