Karcher K7000G Shutting Down & Clean-Up, TAKING A BREAK... five minutes or more, Cleaning Tips

K7000G Manual 11/30/01 5:04 PM Page 8

SHUTTING DOWN & CLEAN-UP

Step 1 Remove	Step 2	Step 3	Step 4
detergent suction tube	Turn off the engine.	Turn off the	Press trigger to
from container and insert		water source.	release water
into one gallon of fresh			pressure.
water. Siphon water at low
pressure for one minute.

7

Step 5 Disconnect	Step 6 Disconnect the high pressure hose from the
the garden hose from the	high pressure outlet and engage the gun safety lock.
water inlet on the unit.

TAKING A BREAK... five minutes or more

Step 1 Turn off the	Step 2 Press trigger	Step 3 Engage gun
engine.	to release water pressure.	safety lock.

WINTERIZING AND LONG-TERM STORAGE

CLEANING TIPS

Deck Cleaning

(with or without detergent)

Pre-rinse deck and surrounding area with fresh water. If using Kärcher Deck Wash, place detergent suction tube directly into cleaning solution and apply to surface at low pressure. For best results, limit your work area to smaller sections of approxi- mately 25 square feet. Allow Kärcher Deck Wash to remain on surface 1-3 minutes. Do not allow detergent to dry on surface. Rinse at high pressure in a long sweeping motion keeping the spray nozzle approximately 6 inches from the cleaning surface. Always clean from top to bottom and from left to right. When moving on to a new section of the cleaning surface, be sure to overlap the previous section to eliminate stop marks and ensure a more even cleaning result.

House Siding

(with or without detergent)

Pre-rinse cleaning surface with fresh water. If using Kärcher House Wash, place deter- gent suction tube directly into cleaning solution and apply to surface at low pres- sure (for best results, limit your work area to sections of approximately 6 feet and always apply detergent from bottom to top). Allow Karcher House Wash to remain on surface 1-3 minutes. Do not allow detergent to dry on surface, if surface appears to be drying, simply wet down surface with fresh water. Rinse at high pressure from top to bottom in an even sweeping motion keep- ing the spray nozzle approximately 6 inches from the cleaning surface.

Cement Patios,

Brick and Stone

(with or without detergent)

Pre-rinse cleaning surface with fresh water. If using Karcher All Purpose Cleaner, place detergent suction tube directly into cleaning solution and apply to surface at low pres- sure. For best results, limit your work area to smaller sections of approximately 25 square feet. Allow Kärcher All Purpose Cleaner to remain on surface 1-3 minutes. Do not allow detergent to dry on surface. Rinse at high pressure in a sweeping motion keeping the spray nozzle approxi- mately 3-6 inches from the cleaning sur- face. Always clean from top to bottom and from left to right.

Cars, Boats & Motorcycles

(with or without detergent)

Pre-rinse vehicle with fresh water. If using Karcher Vehicle Wash, place detergent suc- tion tube directly into cleaning solution and

apply to surface at low pressure. For best 8 results, clean one side of vehicle at a time

and always apply detergent from bottom to top, do not allow detergent to dry on sur- face. Rinse at high pressure in a sweeping motion keeping the spray nozzle approxi- mately 8 inches from the cleaning surface (distance should increase when rinsing pin- striping or other sensitive surfaces). Always clean from top to bottom and from left to right. For best results, wipe surface dry with a chamois or soft dry cloth.

1.Disconnect all water connections.

2.Start the machine for a few seconds, until the water which had remained in the pump exits. Turn off immediately.

3.Drain the gas and oil from the engine.

4.Do not allow high pressure hose to become kinked.

5.Store the machine and accessories in a room which does not reach freezing temperatures. The machine should not be

placed near an open flame i.e. furnace, hot water heater etc.

Caution: Failure to follow the above direc- tions will result in damage to the pump assembly and accessories.