IMPORTANT PRECAUTIONS - continued, Assembly Instructions

IMPORTANT PRECAUTIONS – continued

•Water hose must be at least a 1/2 inch or 5/8 inch in diameter.

•Flow rate of water supply must not fall below 2 GPM (gallons per minute).

•Flow rate can be determined by running the water for one minute into an empty 5-gallon container.

•The water supply temperature must not exceed 104°F/40°C.

•Never use the pressure washer to draw in water contaminated with solvents, e.g. paint thinners, gasoline, oil, etc.

NOTE: Dirt in the feed water will damage the unit. To avoid this risk, we recommend fitting a water filter.

•Always prevent debris from being drawn into the unit by using a clean water source and an accessory water filter if required.

Step 1	Step 2	Step 3
Attach the handle to the frame	Attach the gun/hose storage	Insert the detergent tray into
of the pressure washer. Align	handle.	the slot.
holes, insert bolts, and
thighten with the knobs.

Step 4	Step 5
Screw in the fastener.	Pull out the locking slide from
	the right side of the trigger gun
	handle. Insert the small end of
	the high pressure hose into
	place.

Step 6

Push the locking slide back into the trigger gun to lock the hose in position.