ASSEMBLY INSTRUCTIONS cont.
4. Attach the ballast to the power cord. Use care to align the
– the
Fig. 3
5.Plug ballast into a standard 120V 50/60Hz outlet. Turn lamp on. The green LED indicator on center of the ballast should be illuminated. (Fig. 4) If the LED indicator does not illuminate,
please refer to the troubleshooting section of this manual. (See page 9)
6.If bulb does not illuminate instantly, please refer to the troubleshooting section of this manual.
7.Adjust lamp brightness to the desired level (low-
WARNING: Do not block vents on ballast. Vents are necessary for proper function of the ballast;
blocking them may cause overheating of the Fig. 4 ballast and increase risk of fire.
Attention!
Lift your lamp by the vertical shaft.
6