MANUAL LOWERING TO PARK POSITION
MANUAL LOWERING
1.In the centre of the antenna (arrowed) there is a plastic cap. Lever this off with a narrow
2.Behind the cap is an M8 hexagon head screw. Unscrew these using a 13 mm socket wrench.
After removing the M8 screw, a further thread can be seen.
3.Attention! Secure and support the antenna to prevent it tipping over. The connection to the rocker can suddenly come loose during the next step (item 4). It is then no longer connected to the turntable!
4.Screw an M12 screw into this thread (minimum length: 22 mm). You will need a socket wrench for this (size: 19 mm). Screwing in the M12 screw pushes the rocker off the tapered shaft and releases the engagement.
Attention: Insert the screw only as far as necessary to free the rocker from engagement on the tapered shaft!
5.Tilt the antenna into the park position (horizontal position).
6.Remove the M12 screw. This allows the rocker to
7.Replace the M8 screw and tighten it.
8.Replace the plastic cap.
Loosening the rocker from the taper shaft causes the rocker zero point position to be lost. When the authorised dealer rectifies the defect he will recalibrate the rocker!
9.Consult an authorised dealer.
31
