SPECIAL MESSAGES FROM THE TURNTABLE
SYSTEM PROTECTION MESSAGES
The following messages are shown on the screen to protect your reception system and the
The power supply to the turntable is insufficient (battery voltage below minimum value). The turntable can still be moved, but communication errors can occur between the UFS 740sw and the turntable (e.g. when scanning for satellites).
If the voltage falls still further, both the following error messages are displayed:
Check the power supply to the turntable and whether it is obstructed (e.g. by a branch). If both causes of faults are displayed, the turntable motor temperature is in the critical range. Allow the turntable to stand for a few minutes in its current position, until the turntable motor temperature has reduced. You can also however move the turntable to the park position and let it cool down there.
Press the button and the turntable will move to the park position.
Press the button to confirm the displayed message. The turntable cannot be moved any more. Check the power supply to the turntable.
Note: The antenna should not be moved whilst the battery is being recharged, to prevent peak loads when turning on.
53
