Kathrein UFC 861si manual Remote Control RC, Setting via menu as of software version

REMOTE CONTROL

REMOTE CONTROL RC 660

The RC 660 remote control supports up to four devices which are supplied with the RC 660 as standard.

First, switch off all other receivers (mains switch).

1. Setting via menu (as of software version 1.01)

For the UFS 822, the remote control code does not have to be entered manually. You can easily select one of the four existing remote control codes in the menu (see menu “System setup”, “STB management”, “Remote control code”).

Notice: As of software version 1.01, the remote control code can only be modified through the menu. Manual modifications will not be saved by the receiver.

2. Manual setting (only possible if the software version is older than 1.01)

Switch on the relevant receiver.

On the remote control simultaneously press

Address 1 =  +  + 

Then switch the receiver off again at the power switch and do the same for the other units ( +  +  for the second receiver;  +  +  for the third receiver and

+  + for the fourth receiver) Make sure only one receiver is on at a time!

To switch the remote control to an infrared code:

When you have confi gured all receivers to their infrared code, to switch between units on the remote control do the following:

For operating the first receiver (address 1), press

+ , for the second receiver  + , for the third receiver  +  and

for the fourth receiver  + .

+ (red) = Kathrein UFD 5xx code for remote control RC 400 The RC 600 and RC 650 remote controls cannot be replaced!

12