Roland Piano owner manual Transmitting Sound Settings Data Transfer, 194, Type of Data to Transmit

Transmitting Sound Settings/Reset to Default Factory Settings

Transmitting Sound Settings (Data Transfer)

Sound generator settings and system settings stored in the Fantom’s internal memory or on a Wave Expansion Board can be transmitted to an external MIDI device, or to user memory.

Transmitting Data to an External MIDI Device

Patch, rhythm set, multitimbre, performance, and setup and system settings will be transmitted to an external MIDI device. This operation is called bulk dump. Use this operation when you want to connect another Fantom and play it using the same settings, or to save your data on an external MIDI device as a precaution against possible loss of sound data or system settings.

To transmit data to an external MIDI device, connect the external MIDI device and Fantom as shown in the diagram.

fig.17-01.e

MIDI IN

MIDI Sequencer

MIDI OUT

Fantom

1. Press [MENU] to open the Menu window.

2.Press or to select “Data Transfer,” and then press [8 (Select)].

The Data Transfer window appears.

3.Move the cursor to “Destination” and select “MIDI.”

fig.17-02.e

Type of data to transmit Transmit destination

Transmit source data

4.Move the cursor to “Source” and use the following choices to specify the data that will be transmitted.

Type of data to transmit	Transmit source data
ALL	USER	—
	TEMP	—
SETUP	—	—
SYSTEM	—	—
PATCH	USER	001–128
	TEMP
RHYTHM	USER	001–016
	TEMP	—
MULTITIMBRE	USER	01–16
	TEMP -PATCH	*1
	TEMP +PATCH	*2
	CTRL	—
PERFORMANCE	USER	01–64
	TEMP -PATCH	*1
	TEMP +PATCH	*2
	CTRL	—

*1 Only the current multitimbre/performance settings will be transmitted. *2 The current multitimbre/performance settings and the setting of a

patch or rhythm set assigned to the part will be transmitted.

Type of Data to Transmit

ALL: Patch, rhythm set, multitimbre, and performance

SETUP: Setup

SYSTEM: System

PATCH: Patch

RHYTHM: Rhythm set

MULTITIMBRE: Multitimbre

PERFORMANCE: Performance

Transmit Source Data

USER: Data from user memory will be transmitted.

TEMP: Transmit the data from the temporary area.

CTRL: The state of the multitimbre/performance (e.g., the multitimbre/performance bank select and program changes) will be transmitted as MIDI channel messages, not as exclusive messages.

Refer to “MIDI Implementation” (Sound/Parameter list) for more on the Control Change messages that are received.

5.Set the external MIDI device so that it will be ready to receive data, and press [8 (Execute)] to execute data transmission.

While the data is being transmitted, the display will indicate “Processing...” When “Complete !” is displayed, the transmission has been completed.

To halt during transmission, press [EXIT].

194