Roland Piano owner manual Equalizer settings EQ, Phrase Preview Settings Preview, 185

Settings Common to All Modes (System Function)

Pedal 1, 2 Polarity

Selects the polarity of the pedal. On some pedals, the electrical signal output by the pedal when it is pressed or released is the opposite of other pedals. If your pedal has an effect opposite of what you expect, set this parameter to “REVERSE.” If you are using a Roland pedal (that has no polarity switch), set this parameter to “STANDARD.” Value: STANDARD, REVERSE

Beam Sens (D Beam Sensitivity)

This sets the D Beam Controller’s sensitivity. The higher the value set, the more readily the D Beam Controller goes into effect. Normally you will leave this at “5.”

Value: 1–10

Equalizer settings (EQ)

For details on the setting, refer to “How to Make the System Function Settings” (p. 178).

Equalizer settings are made separately for each output jack Output A(L)/1: OUTPUT A (MIX) jack (L (MONO))/ INDIVIDUAL 1 jack

Output A(R)/2: OUTPUT A (MIX) jack (R)/INDIVIDUAL 2 jack

Output B(L)/3: OUTPUT B jack (L)/INDIVIDUAL 3 jack

Output B(R)/4: OUTPUT B jack (R)/INDIVIDUAL 4 jack

EQ

EQ Switch (Equalizer Switch)

Switch the equalizer on/off.

Value: BYPASS, ON

Low Freq (Low Frequency)

Selects the frequency of the low range.

Value: 200, 400 Hz

Low Gain

Adjusts the gain of the low frequency. Positive (+) settings will emphasize the low-frequency range.

Value: -15– +15 dB

High Freq (High Frequency)

Selects the frequency of the high range.

Value: 2000, 4000, 8000 Hz

High Gain

Adjusts the gain of the high frequency. Positive (+) settings will emphasize the high-frequency range.

Value: -15– +15 dB

Phrase Preview Settings (Preview)

Specify how the phrase will sound when you press [8 (Prevu)] in the Patch List window.

For details on the setting, refer to “How to Make the System Function Settings” (p. 178).

Preview

Preview Mode

SINGLE: The notes specified by Note Number 1–4 parameter will sound successively one by one.

CHORD: The notes specified by Note Number 1–4 parameter will sound simultaneously.

PHRASE: The Phrase associated with the patch’s type/category is

played.

Note Number 1–4 (Preview Note Number 1–4)

Specify the pitch of the four notes that will sound when the Preview Mode parameter is set to “SINGLE” or “CHORD.”

Value: C-1–G9

If “PHRASE” is selected for the Preview Mode parameter, these settings will have no effect.

Velocity 1–4 (Preview Velocity 1–4)

Specify the velocity of the four notes that will sound when the Preview Mode parameter is set to “SINGLE” or “CHORD.” Value: 0–127

If “PHRASE” is selected for the Preview Mode parameter, these settings will have no effect.

Settings Common to All Modes (System Function)

185