Roland Piano Editing Songs, → Track Destination Track, → Measure Destination Measure, Status

Editing Songs

→Track (Destination Track)

Check/modify the copy-destination track or pattern.

Value

ALL: Phrase tracks 1–16, the beat track, and the tempo track

TRK 1–TRK 16: The specified phrase track

TEMPO: Tempo track

PTN001–PTN100:The specified pattern

•If you set the source track to “ALL,” the destination track can be set to either “ALL” or “PTN001–PTN100.” If you select “PTN001–PTN100,” the data from the 16 phrase tracks will be merged as it is copied.

•If “TEMPO” is selected as the source track, then only “Tempo” can be selected for the destination track.

→Measure (Destination Measure)

Check/modify the copy-destination measure.

If you want the copy destination to be right after the last measure of a song, set this parameter to “END.”

Mode (Copy Mode)

Specifies whether you want to preserve the existing data in the copy destination when copying.

Value

MIX: Combines the data from the copy source with the existing data in the copy destination.

REPLACE: Musical data in the copy destination will be erased (i.e., overwritten) when the copy takes place. Only the sequencer data of the MIDI channels specified by the Channel parameter will be overwritten, and data of other MIDI channels will remain.

Times (Copy times)

Specifies the number of times that the data will be copied to the copy destination.

Status

Selects the type of data to be copied.

Value

ALL: All types of sequencer data

NOTE: Note

P.AFT: Polyphonic Aftertouch

C.C: Controller numbers

PROG: Program numbers

C.AFT: Channel Aftertouch

BEND: Pitch Bend

EXC: System Exclusive messages

Tune: Tune Request

PTN: Pattern Call Message data

If the source track is set to “TEMPO,” the Status parameter will not be available.

Range

If you have selected “NOTE,” “P.AFT,” “C.C,” or “PROG” for the Status parameter, specify the range. Specify the minimum value of the range at the left, and the maximum value at the right.

•To copy all Note or Polyphonic Aftertouch data, specify “C-1– G9.” To copy C4 Note/Polyphonic Aftertouch data, specify “C4– C4.”

•If you want to copy all controller numbers, set this to “0–127.” If you want to copy all program numbers, set this to “1–128.” To copy number 4, set “4–4.” To copy numbers from 3 to 14, specify “3–14.”

Channel (MIDI Channel)

Selects the MIDI channel of the data to be copied.

When you want to copy all the sequencer data, set this parameter to “ALL.” To copy only the sequencer data of a specific MIDI channel, select the MIDI channel.

Value: ALL, 1–16

If you set the source track to “TEMPO,” or if the Status parameter is set to “EXC,” “TUNE” or “PTN,” the Channel parameter will not be available.

8.When you have finished making settings, press [8 (Execute)] to execute the operation.

144