Roland Piano owner manual Additional Functions of the Fantom and Changes in Operation

Additional Functions of the Fantom and Changes in Operation

Linked settings for Loop mode

See pp. 139, 125, 130 in the Owner’s Manual

In the Loop window, you can now select the loop modes (POINT, 1 MEAS, 2 MEAS, 4 MEAS, 8 MEAS, 16 MEAS, SONG ALL).

The new Loop window

The selection here is linked with both Loop Play and Loop Recording. In other words, the settings you make in the Loop window will be applied to the Loop settings for playback, as well as to the loop settings for recording in the Recording Standby window.

Loop on/off settings are also linked between the various PATCH PLAY, PERFORMANCE PLAY, and MULTITIMBRE PLAY screens, and in the Loop, Song Edit, and Recording Standby windows.

Category name display in the MULTITIMBRE PLAY screen

See pp. 106, 34 in the Owner’s Manual

If the Patch List window or the Rhythm List window are set to display sorted by categories (i.e., when [7 (Ctg)] has a check mark (✔) assigned), the category name for the selected patch will be displayed in the MULTITIMBRE PLAY screen.

Undo and Redo in the MULTITIMBRE PLAY screen

See p. 109 in the Owner’s Manual

After editing Patch or Volume settings in the MULTITIMBRE PLAY screen, you can revert to the original value (Undo), or set the edited value again (Redo).

To revert to the original value, hold down [JUMP] and press [INC] or [DEC]. To set the edited value again, hold down [JUMP] again and press [INC] or [DEC].

Copy between performances and multitimbres

See pp. 92, 113 in the Owner’s Manual

In the Performance Copy window and Multitimbre Copy window, an “All” setting has been added to Mode. When you use this mode, all name, effect, and part settings can be copied between performances and multitimbres.

New type added to performance and multitimbre initialize

See pp. 91, 112 in the Owner’s Manual

In the Performance Initialize window and Multitimbre Initialize window, a new “SOUND CONTROL” selection has been added to the Type field. This lets you set the following parameters for the specified part (Part: All, 1–16) to the stored value (Value: STORED) or the factory-set value (Value: DEFAULT).

Cutoff Offset	Resonance Offset
Attack Time Offset	Release Time Offset
Decay Time Offset	Vibrato Rate
Vibrato Depth	Vibrato Delay

Quantize all tracks at the same time

See p. 140 in the Owner’s Manual

In the Track Edit (Quantize) window, you can now select “All” for Track (target track).

This allows you to simultaneously perform quantization on all tracks: phrase tracks 1–16, beat track, and tempo track.