Kawasaki 840223 Removing / Attaching Battery Pack Charging Battery Pack, Charger, Assembly

REMOVING / ATTACHING BATTERY PACK

CHARGING BATTERY PACK

REMOVE BATTERY PACK:

1. Press both release buttons on either side of the Impact Wrench to release the battery pack.

2. Pull battery pack free of Impact Wrench.

ATTACH BATTERY PACK:

1. Align the raised portion of the bat- tery pack with the groove in the battery compartment of the Impact Wrench.

2. Press the battery pack into place.	RELEASE
Make sure the latches are securely
	BUTTON
fastened. Do not use the Impact

CHARGE BATTERY PACK:

1.Make sure the trigger on the Cordless Impact

Wrench is in the “OFF” position and remove the battery pack from the Impact Wrench.

2. Insert the battery pack into the charger. Be sure that the battery pack is fully seated in the charg- er. Do not force.

3.Plug the charger into the nearest 120 volt, electrical outlet. The indicator light will come “ON”.

BATTERY PACK

120V AC

ADAPTER

LED LIGHT

BATTERY

CHARGER

Wrench if the battery pack is not

seated properly.

CHARGER

Before using battery charger, please read carefully all instructions and cautionary markings on battery charger, battery pack and product using battery.

The charger will not automatically turn “OFF” when the battery pack is fully charged. The charging indicator light will remain “ON” until the charger is disconnected from the electrical outlet.

Use only the charger which accompanied your product or direct replacement as listed in this manual. Do not substitute any other charger. Use only Alltrade approved chargers with your product.

Do not disassemble charger.

Do not use charger if it has been damaged, left outdoors in the rain, snow, wet or damp environments, or immersed in liquid.

The battery pack and charger heat during charging. Place the charger on a flat, non-flammable surface away from flammable materials with at least four inches of clearance to allow proper air circulation around the charger and battery pack.

When the battery pack requires recharging, a 3-5 hour charge allows the tool to operate at full power. A charging indicator light on the charger will illuminate to show that charging is taking place.

IMPORTANT INFORMATION FOR RECHARGING HOT BATTERIES

When using your Cordless Impact Wrench continuously, the batteries in your bat- tery pack will become hot. You should let a hot battery pack cool down for approx- imately 30 minutes before attempting to recharge. When the battery pack becomes discharged and is hot, the red light on the charger will flash. When the battery pack cools down, the red light will glow continuously.

This will occur when continuous use of your Cordless Impact Wrench causes the battery pack to become hot. It does not occur under normal circumstances.

ASSEMBLY

Be aware that this tool is always in an operating condi- tion because it does not have to be plugged into an electrical outlet. Always turn the switch “OFF” and remove the battery pack before changing bits.

12