LASER SAFETY
NEVER LOOK INTO THE LASER BEAM. Any contact with the eyes by the beam could cause injury. Do not use the laser when cutting reflective materials.
DO NOT AIM THE LASER BEAM AT ANYONE OR AT REFLECTIVE SURFACES. CLASS 2M LASER PRODUCT. Any contact with the eyes by the beam could cause injury. Ensure the laser beam is turned on only when the tool is on a non- reflective workpiece and as such it is aimed only at the work surface. Metals and other materials like steel which can be highly reflective should only be cut with- out the use of the laser.
STORE OUT OF REACH OF CHILDREN. Equipment should be in a high location or locked up to keep out of reach of children. It is not a toy.
DO NOT TAMPER WITH THE LASER OUTPUT. Changing the performance of the laser to increase its output is prohibited. Any claim for damages or injuries resulting from not following these instructions will be refused.
OPERATION ACCESSIBLE FIELDS: |
|
Wavelength | |
Laser Power for Classification | <1mW CW |
NEVER OPERATE LASER IF THE UNIT IS DEFECTIVE OR THE COVER OR SEAL IS DAMAGED.
DO NOT SERVICE LASER. The laser unit must be returned to the factory for any service or repair. Service or repair must be handled by authorized factory trained technicians.
Do not open the laser unit except to change batteries.
REMOVE BATTERIES IF THE LEVEL IS TO BE STORED FOR ANY LENGTH OF TIME. Batteries may leak and damage the laser if it is stored idle for more than 3 months.
Be careful with this tool. Striking or jarring it, especially on the laser housing, can affect its accuracy.
Other than batteries, there are no
ALIGNING THE LASER
The laser must be aligned with the blade before use. If the laser is not aligned properly, your cuts will not be accurate.
TO ALIGN THE LASER:
1. The trigger switch and the laser switch must be in the OFF position.
2. Put a padlock or screwdriver through the hole in the trigger switch to make sure the blade cannot be started accidentally.
3. Plug in the power cord.
4. Turn on the laser switch.
ALIGNING THE LASER
5.Loosen the laser cover screws and
pull off the laser cover, leaving the screws in place.
6.Loosen the screws on the laser unit until it can be moved easily.
7. Align the laser light line with either the left or right side of the blade. Make sure the light is right against the blade. Extra space between the laser line and the blade will lead to inaccurate cutting.
8.Once the laser light line is properly positioned, tighten the laser unit screws.
9.Push the laser cover back into place and tighten the laser cover screws.
Laser light should be kept OFF when not in use.
OPERATING INSTRUCTIONS FOR THE MITER SAW
Do not use the Miter Saw if the power cord (or extension cord, if used) is worn, cut, or damaged in any other way. A worn or damaged power cord must be replaced immediately. Contact Alltrade Customer
LASER LIGHT DO NOT VIEW DIRECTLY WITH OPTICAL INSTRUMENTS (MAGNIFIERS) CLASS 2M LASER PRODUCT
AVOID EXPOSURE -
LASER LIGHT IS EMITTED
FROM THIS APERTURE.
LASER RADIATION
CAUTION LABEL
Service to obtain the proper replacement power cord. Failure to adhere to this warning could result in damage to the Miter Saw motor, fire, or severe electrical shock or even death to the operator.
18
