FENCE BRACKET
TABLE EXTENSION
BAR CLAMP
WING SCREW
ASSEMBLING THE TABLE EXTENSIONS
7.Push the arms through the second set of holes until the ends touch the base of the saw.
8.Carefully tighten the bar clamp screws until the table extensions are held firmly in place. Turn the lock nuts clockwise to keep the screw from loosening.
9.Repeat Steps 4 through 8 for the table extension on the other side. 10.Unfasten the saw and carefully lower it down onto the workbench.
ATTACHING THE VISE
Position the
ATTACHING THE VISE
MOUNTING THE SAW
DO NOT use the Miter Saw until it is securely mounted. An unmounted saw may shift or move unexpectedly during use, causing personal injury and/or property damage.
15
The Miter Saw must be firmly mounted to a workbench or other sturdy work sur- face before use. Once the mounting location is selected, attach the saw to the bench with wood screws.
If a more portable mounting site is desired, the saw may be attached to a 3/4" piece of plywood. Make sure all four mounting feet are securely anchored to the plywood. Before using saw, clamp the plywood to sawhorses or other stationary mounting surfaces. Make sure the location is firm and level and allows enough room to safely maneuver the workpiece.
MOUNTING THE SAW
Table extensions must be installed before mounting saw.
LASER GUIDE
Use of controls or procedures, or performance of proce- dures other then those specified herein may result in hazardous radiation exposure.
16
