PROHIBTION
Do not attempt to remove or repair any component unless instructed by factory.
Make sure that the unit is not resting on or against the electrical cord and the plug.
Do not store any flammable and explosive gas or liquids inside the unit.
Do not attempt to alter or tamper with the electrical cord.
INSTALLATION
IMPORTANT!!! PLEASE READ BEFORE INSTALLATION
The refrigeration system operates most efficiently when installed in an area with cool, dry air circulation.
There must be at least 6 inches of clearance on both sides and the back of the cabinet.
Select a location away from the heat and moisture generating equipment such as stoves, ovens, etc.
Avoid direct sun rays.
Make sure all accessories are installed (i.e. shelves, shelf clips, casters) before plugging the unit in.
Please read through the manual in its entirety.
CABINET LOCATION GUIDELINES
Install the unit on strong and leveled surfaces
•Unit may make unpleasant noises if surface is uneven
•Unit may malfunction if surface is uneven
Install the unit in an indoor, well‐ventilated area
•Unit performs more efficiently in a well‐ ventilated area
•For best performance, please maintain clearance of 4” on the back of the unit.
•Outdoor use may cause decreased efficiency and damage to the unit.
Avoid installation in a high humidity and/or dusty area
•Humidity could cause unit to rust and decrease efficiency of the unit
•Dust collected on the condenser coil will cause unit to malfunction. Clean the condenser at least once a month with a brush or a clean cloth.
Select a location away from heat and moisture‐ generating equipment
•High ambient temperatures will cause the compressor to overwork, leading to higher energy bills and gradual breakdown of the unit
ELECTRICAL
Please ensure that the required voltage of the compressor is being supplied at all times. Low or high voltage can detrimentally affect the refrigeration unit. All units should be plugged into a grounded and properly sized electrical outlet with appropriate overcurrent protection. Please refer to the electrical requirement on the nameplate. Please make sure that your unit has its own dedicated outlet. Do not use an extension cord.
The temperature controls are preset at the factory to maintain an average temperature of 38 F in refrigerators. To maintain a different temperature, simply adjust the control knob located inside the unit.
3
