Kenmore 110.6704, 110.6703 Style 2 Direct wire strain relief, Wire connection Power supply cord

Put power supply cord through the strain relief. Be sure that the wire insulation on the power supply cord is inside the strain relief. The strain relief should have a tight fit with the dryer cabinet and be in a horizontal position. Do not further tighten strain relief screws at this point.

Style 2: Direct wire strain relief

Unscrew the removable conduit connector and any screws from a 3/4"(1.9 cm) UL listed strain relief (UL marking on strain relief). Put the threaded section of the strain relief through the hole below the terminal block opening. Reaching inside the terminal block opening, screw the removable conduit connector onto the strain relief threads.

Electrical Connection		Options
If your home has:		And you will be			Go to Section:
		connecting		to:
4-wire	receptacle	A UL listed,			4-wire connection:
(NEMA type 14-30R)		120/240-volt			Power Supply
		30-amp, dryer
	(_	power	supply		Cord
		minimum,
		cord*
4-wire	direct	A fused			4-wire connection:
		disconnect		or	Direct Wire
		circuitbox*	breaker
	(12.7 crn)
3-wire	receptacle	A UL listed,			3-wire connection:
(NEMA type 10-30R)		120/240-volt			Power Supply
		30-amp, dryer
		power	supply		Cord
		minimum,
		cord*
3-wire	direct	A fused			3-wire connection:
		disconnect		or	Direct Wire
		box*	breaker
		circuit

L!	B	* If local codes do not permit the connection of a cabinet-ground
		conductor to the neutral wire, go to "Optional 3-wire
		connection" section.

..........C

A. Removable conduit connector

B. Hole below terminal block opening

C. Strain relief threads

Put direct wire cable through the strain relief. The strain relief should have a tight fit with the dryer cabinet and be in a horizontal position. Tighten strain relief screw against the direct wire cable.

4-wire connection: Power supply cord

IMPORTANT: A 4-wire connection is required for mobile homes

and where local codes do not permit the use of 3-wire connections.

BF

C DEG

A. 4-wire receptacle (NEMA type 14-30R)

B. 4-prong plug

C. Ground prong

D. Neutral prong

E. Spade terminals with upturned ends

F. _" (1.9 cm) UL listed strain relief

G. Ring terminals

4.Now complete installation following instructions for your type of electrical connection:

4-wire (recommended)

3-wire (if 4-wire is not available