Kenmore 110.6704 To make changes during an Auto Dry Cycle, To use a Timed Cycle, Drying tips

To make changes during an Auto Dry Cycle:

•PressSTOR

•Adjust Dryness Level.

NOTE: Dryness Level selections can be made only while using Auto Dry Cycles.

More

Normal

Less

Dryness

Level

Auto Dry Cycles take the guesswork out of drying time and enhance fabric care. The amount of time that is

displayed is the estimated time remaining in the cycle.

To use a Timed Cycle

Select a Timed Cycle.

Press the TIME ADJUST (More Time or Less Time) buttons until the desired drying time is displayed. Press MORE TIME or LESS TIME once and the time will change by 1-minute intervals. Press and hold MORE TIME or LESS TIME and the time will change by 5-minute intervals.

NOTE: The Time Adjust feature can be used only with Timed Cycles.

Time Adjust

•Press TEMPERATURE until the desired temperature illuminates.

NOTE: During a Timed Cycle, you can change the settings for Time, Temperature, WRINKLE GUARD _ and Cycle Signal.

NOTE: The Temperature feature can be used only with Timed Cycles.

5, (OPTIONAL STEP) If desired, select OPTIONS. For more details, see "Options."

6.(OPTIONAL STEP) If desired, press CYCLE SIGNAL. A signal will sound to alert you when a cycle ends. For more details, see "Cycle Signal."

7, Press START. Be sure the door is closed.

•If you do not press Start within 5 minutes of selecting the cycle, the dryer automatically shuts off.

•If you wish to end your drying cycle after pressing Start, press STOP twice.

To stop or pause your dryer at any time

Open the door or press STOP once. Press STOP twice to cancel a cycle.

To restart the dryer

Close the door. Press START until dryer starts.

NOTE: Drying will continue from where the cycle was interrupted if you close the door and press Start within 5 minutes. If the cycle is interrupted for more than 5 minutes, the dryer will shut off.

Select new cycle settings before restarting the dryer.

Select the correct cycle and dryness level or temperature for your load. If an Auto Dry Cycle is running, the display shows the

estimated cycle time when your dryer is automatically sensing the dryness level of your load. If a Timed Cycle is running, the display shows the exact number of minutes remaining in the cycle.

Cool Down tumbles the load without heat during the last few minutes of all cycles. Cool Down makes the loads easier to handle and reduces wrinkling. The length of the Cool Down depends on the load size and dryness level.

Drying tips

•Follow care label directions when they are available.

•If desired, add a fabric softener sheet. Follow package instructions.

•To reduce wrinkling, remove the load from the dryer as soon as tumbling stops. This is especially important for permanent press, knits and synthetic fabrics.

•Avoid drying heavy work clothes together with lighter fabrics. This could cause overdrying of lighter fabrics and lead to increased shrinkage or wrinkling.

Cycle tips

•Dry most loads using the preset cycle settings.

•Refer to the Auto or Timed Preset Cycle Settings charts (in the "Cycles" section) for a guide to drying various loads.

•Drying temperature and dryness level are preset when you choose an Auto Dry Cycle. You can select a different dryness level, depending on your load, by pressing Dryness Level and choosing More, Normal or Less.

NOTE: You cannot use the Time Adjust and you cannot choose a Temperature with the Auto Dry Cycles.

•If you wish to adjust the cycle length of a Timed Cycle, press the Time Adjust (More Time or Less Time) arrows. Adjust the temperature of a Timed Cycle by pressing Temperature until the desired temperature is selected.

NOTE: You cannot choose a dryness level with Timed Cycles.

19