EDGE CLEANER
Active brush edge cleaners are on both
sides of the Power- Mate e Guide either side of the Power- Mate _ along base- boards or next to
furniture to help remove dirt trapped at carpet edges
OVERLOAD PROTECTOR
The
should the brush jam° If the brush slows down or
stops, the overioad protector button pops up and shuts off the Power- Mate *, The canister motor will continue to run
To correct problem', See
TROUBLESHOOTINGo
To reset: Push in the overload protector button°
SUCTION CONTROL
The suction control allows
you to change the vacuum
suctionsucfion suction for different fabric
and carpet weight& Opening the controt decreases suction for draperies and lightweight rugs, while closing the control increases suction for upholsteries and carpets.
WARNING
Personal Injury Hazard
Always unplug the vacuum cleaner before cleaning the brush area as brush may suddenly restart, Failure to do so can result in personal injury.
PERFORMANCE INDICATOR
SOME MODELS
tf the performance indi- cator turns entirely red check for a full dust bag, or a ciog in the vacuum,
See HOW YOUR VACUUM WORKS.
NOTE: The performance indicator may turn red when using attachments or when clean- ing new carpet, due to reduced airflow by the attachments themselves or new carpet fuzz filling the bag quickly.
POWE R-MATE s STO RAG E SOME MODELS
The lower wand has a "U" shaped flange in the area where the power cord attache& The base has a "U" shaped slot near the front caster,
The slot allows the wands and Power- Mate e to be stored with the canister to
conserve storage space., The canister must be stored on end for this feature to be used.
The wand will slip out of the slot as it is lift- ed up for use and will slide into the slot as it is lowered for storage_
THERMAL PROTECTOR
This vacuum has a thermal protector which automatically trips to protect the vacuum from overheating The thermal protector turns the motor off automatically to allow the motor to cool in order to prevent possible damage to the vacuum.
To reset: Turn off and unplug the vacuum from the outlet to allow the vacuum to coot Check for and remove any clogs, Also check and replace any clogged filters.
Wait approximately 50 minutes and plug the vacuum in and turn back on to see if
the thermal protector has reset, In some cases, the unit may suddenly restart, DO NOT leave unattended.
'11