TO REMOVE BELT
1. Remove light cover and light butb as shown under LIGHT BULB CHANGING
2, Unscrew the Power- Mate ® cove r screws,
3, Turn
remove cover, insert
TO REPLACE BELT
1.Slide washers and brush supports onto brush assembly.
screwdriver at cover tabs on both sides and twist to release tabs,
5.Carefully insert and lift screwdriver at each brush
support to |
| |
free | brush |
|
from | base | Brush |
6, Remove | Support | |
| ||
worn | belt, |
|
Tab
4.Turn Power- Mate s right side up, Press handle release pedal and lower the swivel Rotate cover forward from back until front snaps free,
7. Slide brush
supports off to check and clean
brush support areas See
BRUSH ASSEMBLY for picture of complete brush assembly,
2.Install new belt over motor drive, then over brush sprocket.
NOTE: See 1
PARTS AND Brush
FEATURES Support for Belt number,
4.Line up front of cover and base. Rest cover
on front edge of base as shown°
Cover
Motor
Drive
Brush
Brush Sprocket
3o Snap brush supports into place on base, Be sure brush supports are not upside- down
Base
5.Rotate cover back° Press
cover firmly until side tabs snap into place. Replace cover screws, light bulb and light
cover
16
