Kenmore 116.21513, 116.20512 owner manual Two metal washers, Use, Moderate, Light

HALF LIGHT POWER-MATE ® FULL LIGHT POWER-MATE d

2.Push in and turn bulb countercfock- wise to remove,

3.Replace the bulb, Bulb must not

be higher than 15 Watts(130V), Close _ight cover until it snaps in place

1. Remove light cover by lifting at arrow as shown.

1/4

2, Push in and turn bulb counterclock- wise to remove.

3.Replace the bulb Bulb must not

be higher than 15 Watts (130V). Close light cover until it snaps in place,

1, Remove light

cover by pressing in and lifting both sides as shown.

Push In

And Turn

NOTE: See PARTS AND FEATURES for Bulb number_

CAUTaON

When you remove the end caps, a small metal washer on each end

may come off, DO NOT lose these

two metal washers.

TO CLEAN AGITATOR:

NOTE: In order to keep cleaning efficiency high and to prevent damage to your vacuum, the agitator must be cleaned every time the belt is changed_,

The agitator must also be cleaned according to the following schedule:

Vacuu_	Use		Clean	Agitator
HEAVY	-		every	week
(used	daily)
MODERATE		-	every	month
(used	2-3	times/week)
LIGHT	-		every	2 months
(used	1 time!week)

NOTE: See PARTS AND FEATURES for Bulb number.

Remove any dirt or debris in the belt path area or in the brush roller area.

any string or

debris located on the agitator, end caps, washers or agitator shaft.

IMPORTANT

Replace the washers and the end caps. See the exploded view for correct assembly,

Disconnect cleaner from electrical outlet.

Check and remove hair, string and lint build- up frequently in the Power-Mate ® agitator'

and end cap area& If build-up becomes excessive, disconnect Power-Mate ® from wand and follow the steps below,

15