Harman Stove Company 929 DV Assembly, Removing the Glass Front, Remove and Unwrap the Log Set

ASSEMBLY

The Clarity is shipped from the factory with the log set packed inside the firebox. To prepare the stove for installa- tion, the log set must be unpacked, the appropriate burner system module for either natural gas or propane installed, and the logs installed.

Removing the Glass Front

NOTE: The glass front is heavy. Be prepared for its weight when lifting it to avoid damage during removal.

The wing doors on each side are held closed by mag- nets. Push on each door to open it. Loosen the wing nut on each of the two spring-loaded levers. Grasp each lever and push to the rear to disengage the front. To keep the levers in the disengaged position, tighten the wing nuts. Lift the glass front slightly and remove it from the stove. Set the glass aside in a safe place where it will not be damaged.

Remove and Unwrap the Log Set

As shown in the photo in the right column, the log set consists of a back log (1), a center log that has a pilot-view- ing port in the left end (2), two ember strips (3), and a branch that rests on top (4).

In addition, there are two side brick panels and a back brick panel.

The log set components are shipped from the factory individually wrapped and packed inside the stove. Take them out of the stove, then carefully remove the wrapping. Handle the logs gently as they may be damaged easily.

1

	2
3	4
	3

The front is released when spring-loaded levers on the left and right sides are pushed to the rear

WARNING: Do not abuse the Clarity's glass by striking, slamming, or similar trauma. Do not operate the Clarity Gas Heater with the glass panel removed, cracked or broken. Use only glass supplied by Harman and approved for use with this heater. Do not use substitute materi- als. Replacement of the panel should be done by a licensed or qualified service person.

Installing the Burner System Module

The burner system module may be installed into the fire- box as an integrated unit, and it may help to have an assistant who can assist in guiding the components into position and in making sure that themodule does not siton any wiring compo- nents.

Hold the module at a slight angle, then lower it through the opening and rotate upright until it is in position.

Reach underneath and install one of the wing nuts, finger tight. Then check to see that the module is seated correctly.

A sealing gasket affixed to the bottom of the module's base plate will cause the log support plate to be elevated slightly above the plane of the firebox bottom plate. When the two wing nuts are tightened, this gasket will be compressed and a correct fit will be indicated by thelog support plate becoming flush with the bottom of the firebox.

Install wing nut
on threaded stud	7