Kenmore 116.24614 owner manual To Clean Agitator, To Replace Belt

TO CLEAN AGITATOR:

NOTE: In order to keep cleaning efficiency high and to prevent damage to your vacu- um, the aaitator must be cleaned every time the belt is changed,

The agitator must also be cleaned accord- ing to the following schedule:

Vacuum	Use		Clean	Aaitator
HEAVY	-		every	week
(used	daily)
MODERATE		-	every	month
(used	2-3	times/week)
LIGHT	-		every	2 months
(used	1 time/week)

IMPORTANT

Disconnect cleaner from electrical outlet.

Check and remove hair, string and lint build- up frequently in the Power-Mate ® agitator and end cap areas.

Remove any dirt or debris in the belt path area or in the brush roller area.

Carefully remove any string or debris located on the agitator, or end caps.

Agitator Assembly

Belt Pulley7

Bcush UnH

TO REPLACE BELT

1.Install new belt over

motor	drive,
then	over	or
brush
sprocket.		e
NOTE: See		t
PARTS AND
		End Cap
	Agitator

FEATURES

for belt number.

2. Place agitator assembly back into Power- Mate ® .

3. Line up front of cover and base. Rest cover on

front edge of base as shown.

CoverBase

4.Rotate cover

back. Press _.,..'_

cover firmly until __:_.__

side and rear _/_L_'V_J_._.-,',T_ tabs snap into __'/:.-..'_.._._

place"__'_

Make sure there Side Rear

Latch Latches

is no gap

between the cover and base.

5.Turn Power-Mate®upside down and replace two (2) cover screws.

17