Kenmore 116.29912 owner manual To Replace Belt, Line up

TO REPLACE BELT

1, Slide washers and end caps onto agitator assembly,

2.Install new belt over motor drive, then over brush sprocket.

NOTE: Use	Motor
belt #20-5201.	Brush Drive
In Canada,	End Cap
#20-4097&

5, Line up

front of cover and base_ Rest cover on

front edge of base as shown,

CoverBase

i ' :::::3 Top View

io

_o

rim

3, Place agitator assembly back into Power-Mate ® ,

4. Reinstall agitator cover by lin- ing up the front tabs and slots and rotating downward

until theAgitator Cover latches

snap into place.

:[

1.Remove Power-Mate e cover as shown in

BELT CHANGING AND AGITATOR CLEAN- ING section.

2. Push in and turn bulb counterclock-

6.NOTE: On dirt sensor models be sure that the

board is upright and the wires are

tucked back as shown.

7, Rotate cover back, Press cover firmly until side and rear tabs snap

into placer Turn Power-Mate ®

upside down and replace two (2)

PUSdhTnurnI

>

k4

3.Push in and turn bulb clockwise, to replace° Bulb must not be higher than 15 Watts (130 Volts),

wise, then pull out to remove.

4.Reinstall Power-Mate e cover as shown in

BELT CHANGING AND AGITATOR CLEAN- ING section,

NOTE: Use bulb #20-5240. tn Canada, #596!81.

19