PRIMARY FILTER CLEANING
it is recommended to clean filter with
cold water at least every three (3) months.
Check the primary filter frequently and clean when dirty.
1.Turn off and unplug vacuum cleaner.
2.Remove the dust bin. Refer to DUST BIN EMPTYING page 17.
3.On the dust
6.Remove primary filter from frame.
Fiffer
bin handle,
push the | Release | |
Button | ||
release | ||
| ||
button, |
|
4. Pull up on the dust bin lid
latch to open dust bin.
5. Remove the filter frame and
Primary filter.
Z Wash primary (foam) filter with cold water only, DO NOT use detergent or
soap. Repeat 10 times or until water runs clear.
8.Once the primary filter is washed clean, squeeze by hand and atlow to air dry.
9.Allow primary filter to air dry 24 hours before putting back into vacuum cleaner.
DO NOT operate without primary filter installed.
DO NOT wash in the dishwasher.
DO NOT install damp.
10.Reinstall the foam filter into the frame and then into the dust bin lid.
11.Close the lid. A noticeable "click" shouldbe heard.
12.Reinstal! dust bin into the vacuum
cleaner. See Dust Bin Emptying section. Refer to page 17.
NOTE: When the cleaning of the primary
filter no longer restores vacuum cleaner suction to full power, replace the primary
filter. Refer to page 5 for replacement
