TO REMOVE DUST BAG
!WARNING
Always unplug power cord from electrical outlet before performing
any maintenance on the vacuum cleaner.
TO REPLACE DUST BAG
1. Unfold the Dust
new dust bag. Bag
Fold the safety seal tab on the
Seal Tab
new dust bag /, away from the //
opening that /
1. Pull out on the bag cover release
located near the |
| |
top of the bag | Bag | |
cover. | ||
|
Bag
3.Grasp the dust bag collar and pull gently,
carefully removing the dust bag.
4.Throw away the used dust bag.
Do not reuse dust bag.
- Beg Holder
Safety
Filter
//_'_
2.Pull the bag cover forward
and lift up.
Remove and lay aside.
,,Dust
Bag
Check the bag holder and the
motor safety fil- ter. If either is
blocked, check
TROUBLE-
SHOOTING.
fits on the bag holder.
NOTE: See PARTS AND FEATURES for B bag number.
2. Insert the dust
bag onto the bag O holder completely
by holding the bag collar.
3.Place the dust bag collar into position.
4.Tuck the bag
behind each of the Bag
four bag retention Retention
Comer
corner flaps shown Flaps here. Be sure the
bottom and sides
of the dust bag are completely within
bag cavity prior to
replacing the bag cover.
5. Position the bag
Slotscover so its posi- tioning tabs fit into the body position- ing tab slots.
CAUTION
NEVER REUSE A DUST BAG.Very fine materials, such as carpet fresh- ener, face powder, fine dust, plaster,
soot, etc. can clog the bag and cause it to burst before it is full.
Change bag more often when vacu- uming these materials.
6.Close the bag cover.
You will hear a
distinct snap Bag when cover is
securely closed.
Check to see that the dust bag is fully enclosed in the bag cover.
15
