Kenmore 122.1643101 manual Manually Lighting Your Grill by Match

Z_ WARNING

Never lean over the grill cooking area while lighting your gas grill. Keep your face and body a safe distance (at least 18 inches) from the cooking grid surface when lighting your grill by match.

Manually Lighting Your Grill by Match

1.Insert a match into the lighting stick.

2.Follow steps 1 through 5 of the Basic Lighting Procedure.

3.Light the match and extend the lighting stick to cooking grid surface.

J

4.Turn the desired control knob to the HI_ position setting to release gas. The burner light immediately.

/

!

\\\\

!WARNING

Should a "FLASH-BACK" fire occur in/or around the burner tubes, follow the instructions below. Failure to comply with these instructions could result in a fire or explosion that could cause serious bodily injury, death, or property damage.

•Shut off gas supply to the gas grill.

•Turn the control knobs to OFF position.

•Put out any flame with a proper fire extinguisher.

•Open grill lid.

•Once the grill has cooled down, clean the burner tubes and burners according to the cleaning instructions found on page 15.

If Grill Still Fails To Light

1.Check gas supply and connections for leaks. Check that all wire connections are secure.

2.Repeat basic lighting procedure. If your grill still fails to operate, turn the gas off at source, turn the control knobs to OFF, then check the following:

•Misalignment of burner tubes over orifices Correction: Reposition burner tubes over orifices.

•Plugged orifice

3. If an obstruction is suspected in grill burner gas

valves, please call for repair service at 1-800-4-MY- HOME.

4.If the grill still does not light you may need to purge air from the gas line or reset the regulator excess gas flow device. Note: This procedure should be done every time a new LP gas tank is connected to your grill.

To purge air from your gas line and/or reset the regulator excess gas flow device:

•Turn the control knob to OFF position.

•Turn all burner control knobs to OFF position.

•Disconnect regulator from LP gas tank.

•Let unit stand for 5 minutes.

•Reconnect regulator to the LP gas tank.

•Turn the tank valve on slowly until 1¼to ½ open.

•Open the grill lid.

•Push and turn any control knob to HIGH.

•Turn control knobs to HIGH until all the burners are lit

•You may start to use the grill

5. If all checks or corrections have been made and you

still have questions about operating your gas grill, call the Grill Information Center at 1-800-913-8999.

17