![](/images/new-backgrounds/1229538/22953823x1.webp)
end of Side Burner Tube goes over tip of Side Burner Valve. Secure Side Burner with supplied Cotter Pin (packed in Side Burner Control Knob
bag) See Fig. 9b. Place Pot Support into position on Side Burner Frame.
. Install the Control Knob to the Side Burner Valve Stem. See Fig. 9b.
. Connect the Ignition Wire terminal from Side Burner with the other from Grill Head. See Fig. 9b. Bind the connected Ignition Wires and Connection Tube together using the supplied Fastening Band.
. The gap between the Side Burner Electrode Tip and the Side Burner Port should be approximately 1/8"~3/16 ''See. Fig. 9c.
7.If the gap is wider than 3/16", use a pair of long
nose pliers and gently bend the Electrode Tip toward the Burner.
. Place the Pot Support into the Side Burner Frame. See Fig. 9b.
. Slide the 5 Tool Hooks onto the Tool Holder with hooks facing the grill Head. Attach Toot Holder to left side of Side Shelf and secure firmly using 2 of the M5x8mm Pattern Head Screws supplied. See
Fig. 9d.
•When you have finished assembling your Grill be sure aN Pattern Head Thumb Screws
are tightened. You may use the supplied Tightening Tool (P55M3A) as needed.
Figure 9b
POT
SUPPORT
\
SIDE
JRNER
COTTER
PIN
VALVE KIT
IGNITION WIRE
FROM SIDE BURNER
3NITION WIRE FROM GRILL HEAD
BAND
Figure | 9c |
|
|
|
| 1/8"~3/16" | BURNER |
SIDE | BURNER | _ | PORT |
_URNER
Figure 9d
TOOLHOOK
TOOL HOLDER
M5x8mm PATTERN
HEAD SCREW
SIDE SHELF
12