Kenmore 141.15227 owner manual Installing The Cabinet Doors, Installing The Grill Head

Install the Door Bracket to the inside of front Cart Legs. Align the threaded holes on the Door Bracket with the holes on Cart Legs. Tighten securely by using 4 of the 1/4"x2" Pattern Head Screws provided. (See Fig. 3. on page 9) Upper

door bolt holes (at ends of bracket) must face outward.

Installing The Cabinet Doors

1.Install the Door Stops to the Bottom Shelf and the Door Bracket. See Fig. 4.

Align the holes on the Door Stops with the threaded holes on the top of the Bottom Shelf and bottom side of Door Bracket. Tighten securely by using 4 of the 1/4"x1/2" Pattern Head Screws provided. See Fig.4.

2.Remove the white protective film from the stainless steel Doors. Attach a Door Handle to

each Front Door by using 2 of the M4x5mm Pattern Head Screws provided. See Fig. 5. Be careful not to scratch the Door surfaces.

3.When installing the Front Doors, make sure the door bolt holes are located on the hinge sides of the Cart Legs.

4.Install either Front Door by inserting 1/4"xl/2" part-threaded bolt through the lower door bolt hole of the Front Door and into the tapped hole of the Bottom Shelf. Next, align the upper door bolt hole of Front Door with the tapped hole in the bottom of Door Bracket. Insert 1/4"x1/2" part-threaded bolt provided and tighten both securely.

5.Repeat these steps to install the other Front Door.

Installing The Grill Head

Now that you've assembled the grill cart you can install the pre-assembled Grill Head. See Fig. 6. If you haven't already done so, we suggest you open the Grill Lid and remove the packed components. Even with the com- ponents removed, this next step requires 2 people.

With an assistant, lift and position the Grill

Head onto the grill cart. Align the 4 holes of the Bowl Side Panel to the threaded holes

on the Cart Leg Bracket. Secure firmly by using 4 of the 1/4"x1/2" Pattern Head Screws provided.

2.Place the Pre-assembled Valve Kit and Ignition Wire through the slot in side of Grill Head as illustrated in Fig. 6.

. Place Heat Shield into Grease Draining Tray. The Heat Shield must be present and centered for your safety. From the back

Figure 4

DOOR

BRACKET

DOOR

Found in

Hardware Pack

BOTTOMSHELF

TANK PULL-OUT

TRAY KIT

Figure 5

DOOR

BRACKET

UPPER DOOR

BOLT HOLE

FRONT

DOOR

DOOR

HANDLE

\

LOWER DOOR

BOLT HOLE BOTTOM

SHELF

Figure 6

GRILL

HEAD

CARTLEG

BRACKET

CART ;:;>

PRE-ASSEMBLED

VALVE KIT

IGNITION WIRE

FROM GRILL HEAD

CART LEG - RIGHT

10