DARNDNG
WITH PRESSER FOOT:
1Turn feed dog control to left,
2Press down outer ring of presser foot knob, see page 10 With presser foot konb in this position, mending, darning, monogram work, ete, may be done.
3Stretch fabric tightly between two spring embroidery hoops and place under needle
4Lower presser bar so thread will have some tension° When you start to darn, move fabric back and forth to cover darning area., Then turn fabric and continue sewing at right angles to the previous stitching. Use medium machine speed You can make any length stitches desired, Slow movement of fabric wilt make short darning stitches, Fast movement will make long stitches
5When you finish darning, raise presser foot and remove fabric Increase pressure for general sewing by pressing down inner pin of the presser foot knob Turn feed dog control to right
WITHOUT PRESSER FOOT:
1, Turn feed dog control to left
2Remove presser foot.
Proceed as directed under steps 3 and 4 above.
3o When you finish darning, raise the presser foot lever and remove fabric, Replace presser foot, and increase pressure for general sewing, Turn feed dog control to right
18
