FIGURE 24.
16.Replace terminal cover on thermostat making sure that the locking tabs on the terminal cover are in place.
FIGURE 25.
17.Replace the insulation to cover the thermostat and the element.
FIGURE 26.
18.Replace access panel.
19.Turn “ON” electric power to water heater.
FIGURE 27.
Drain Valve Washer Replacement.
NOTE: For replacement, use a 17/32” x 13/64” x 1/8” thick washer available at your nearest hardware store. For ordering a replacement washer, refer to the “Repair Parts List” section.
•Before beginning turn “OFF” the electrical power supply to the water heater.
•Follow “Draining” instructions in the “Service and Adjustment” section.
•Turning counter clockwise, remove the hex cap below the screw handle.
•Remove the washer and put the new one in place.
•Screw the handle and cap assembly back into the drain valve and retighten using a wrench. DO NOT OVER TIGHTEN.
•Follow “Filling the Water Heater” instructions in the “Installation Instructions” section.
•Check for leaks.
•Turn “ON” electric power to the water heater.
FIGURE 28.
Anode Rod Inspection
The anode rod is used to protect the tank from corrosion. Most hot water tanks are equipped with an anode rod. The submerged rod deteriorates to protect the tank. Instead of corroding the tank, water ions attack and eat away the anode rod. This does not effect the water’s taste or color. The rod must be maintained to keep the tank in operating condition.
Anode deterioration depends on water conductivity, not necessarily water condition.Acorroded or pitted anode rod indicates high water conductivity and should be checked and/or replaced more often than an anode rod that appears to be intact. Replacement of the depleted anode rod can extend the life of your water heater. Inspection should be conducted by calling the Sears Service Center for an authorized contractor. At a minimum, the anode(s) should be checked annually after the warranty period.
Service
Before calling for repair service, read the “Start Up Conditions” and “Operational Conditions” found in the Troubleshooting section of this manual.
If a condition persists or you are uncertain about the operation of the water heater, let a qualified person check it out.
Contact Sears Repair Services at 1-800-4-MY-HOME (1-800-469-4663).
17
