Kenmore 153.330702 Installation Instructions contd, Facts to Consider About the Location

Models: 153.330752 153.330552 153.330702 153.330502 153.330402

1 28
Download 28 pages 35.46 Kb
Page 9
Image 9
Installation Instructions (cont'd)

Installation Instructions (cont'd)

Facts to Consider About the

Location

You should carefully choose an indoor location for the new water heater, because the placement is a very important consid- eration for the safety of the occupants in the building and for the most economical use of the appliance. This water heater is not for use in mobile homes or outdoor installation.

Whether replacing an old water heater or putting the water

heater in a new location, the following critical points must be observed.

The location selected should be indoors as close as practical to the gas vent or chimney to which the water heater vent is going to be connected, and as centralized with the water pip- ing system as possible. The water heater, as all water heaters,

will eventually leak. Do not install without adequate drainage provisions where water flow will cause damage.

ACAUTION

WATER HEATERS EVENTUALLY LEAK: Installationof the

water heater must be accomplishedin sucha manner that if the tank or any connectionsshouldleak, the flow of water will not causedamageto the structure.For this reason, it is not advisableto installthe water heater in an attic or upperfloor

When suchlocationscannotbe avoided,a suitabledrain pan shouldbe installedunderthe water heater Drain pansareavail- able at your localSearsstore. Such a drain pan must be not greaterthan I½ inchesdeelghavea minimum leng_ and width of at least2 inchesgreater than the water heater dimensions

and must be piped to an adequatedrain. The pan must not restrict combustionair flow. Under no circumstancesis the

manufacturer or Searsto be held liablefor any water damage in connectionwith this water heater

AWARNING

INSTALLATIONS IN AREAS WHERE FLAMMABLE LIQUIDS (VAPORS) ARE LIKELY TO BE PRESENT OR STORED

(GARAGES, STORAGE, AND UTILITY AREAS, ETC): Flammable liquids (such as gasoline, solvents, propane (LP) or butane, etc.), all of which emit flammable vapors, may be improperly stored or used in such areas. The gas water heater

pilot light or main burner can ignite such vapors. The resulting flashbackand fire can cause death or serious burns to anyone in

the area, aswell as property damage.

If installation in such areas is your only option, then the installa.

tion must be accomplished in a way that the pilot flame and main burner flame are elevated from the floor at least 18 inches.

While this may reduce the chances of flammable vapors from

floor spillbeing ignited,gasoline andother flammable substance! shouldnever be stored or used in the same room or area con.

raining a gaswater heater or other open flame or spark produc- ing appliance.

NOTE: Flammable vapors may be drawn by air currents from other areas of the structure to the appliance.

AWARNING

Propellants of aerosol sprays and volatile compounds, (clean- ers, chlorine based chemicals, refrigerants, etc.) in addition to being highly flammable in many cases,will also change to cor- rosive hydrochloric acid when exposed to the combustion : products of the water heater. The results can be hazardous, and also cause product failure.

The location selection must provide adequate clearances for ser- vicing and proper operation o_'the water heater.

AWARNING

This water heater must not be installed directly on carpeting. Carpeting must be protected by a metal or wood panel beneath the appliance extending beyond the full width and depth of the appliance by at least 3 inches (76.2mm) in any direction, or if the appliance is installed in an alcove or closet, the entire floor must be covered by the panel. Failure to heed this warning may result in a fire hazard.

AWARNING

Minimum clearances between the water heater and com- bustible construction are I" at the sides and rear, 4" at the front, and 6" from the vent pipe. Clearance from the top of the

jacket is 18" on most models. Note that a lesser dimension may be allowed on some models. Refer to the label on the water

heater adjacent to the gas control valve for all clearances.

12" MAX

VENTILATION

 

R"N

 

 

 

AIR

 

 

 

OPENINGS O

'1!'MIN

_=_a

_4"M_N"

 

TOP

VIEW

 

, i

OF CLOSET

TOP

VIEW I" MIN.

WITHOUT

DOOR

OF CLOSET

12'MAX

 

WiTH

DOOR

FRONT VIDN

3,,

OF DOOR

 

Figure I ]

AIR DUCT

 

AWARNING

A gas water heater cannot operate properly without the cor- rect amount of air for combustion. Do not install in a confined

area such a closet, unlessyou provide air as shown in the "Facts to Consider about the Location" section. Never obstruct the

flow of ventilation air. If you have any doubts or questions at all, call your gas company. Failure to provide the proper amount of combustion air can result in a fire or explosion and can cause

DEATH, SERIOUS BODILY INJUR_, OR PROPERTY DAMAGE.

AWARNING

If this water heater will be used in beauty shops, barber shops, cleaning establishments, or self-service laundries with dry

cleaning equipment, it is imperative that the water heater or water heaters be installed so that combustion and ventilation

air be taken from outside these areas. Refer to the "Facts to Consider About the Location" section of this manual and also the latest edition of the National Fuel Gas Code, ANSI Z223.1, also referred to as NFPA 54 for specificsprovided concerning

air required.

9

Page 9
Image 9
Kenmore 153.330702, 153.330502, 153.330752 Installation Instructions contd, Facts to Consider About the Location, Awarning