Troubleshooting Guide (cont'd)

HOTCOLD WATERHEATER(3)

COLDWATERPRESSURE

INLET FITTING REDUCING VALVEWITH BY-PASS

Operational Conditions

SMELLY WATER

in each glasslined water heater there is installed at least one

anode rod (see parts section) for corrosion protection of the tank. Certain water conditions will cause a reaction between this

EXPA( I)SIO N _'_

TANK __

PRESSUREGAUGE INLETCOLD

WATER

SHUTOFF

RECOMMENDED INSTALLATION

(VERTICAL MOUNTING)

WATER HEATER

FLOOR, CEILING

COLD WATER

JOIST, ETC.

INLET FITTING

 

HOT

STRAPPING

 

rod and the water. The most common complaint associated with the anode rod is one of a "rotten egg smell". This odor is derived

from hydrogen sulfide gas dissolved in the water. The smell is the restllt of four factors which must all be present for the odor to develop:

a.a concentration of sulfate in the supply water.

b.little or no dissolved oxygen in the water.

c.a sulfate reducing bacteria within the water heater. (This harmless bacteria is non-toxic to humans.)

d.an excess of active hydrogen in the tank. This is caused by the corrosion protective action of the anode.

Smelly water may be eliminated or reduced in some water heater models by replacing the anode(s) with one of less active material, and then chlorinating the water heater tank and all hot water lines. Contact Sears Service for further information concerning

an Anode Replacement Kit #9001453 and this Chlorination Treatment.

If the smelly water persists after the anode replacement and chlo- rination treatment, we can only suggest that continuous chlori-

nation and filtering conditioning equipment he considered to eliminate the water problem.

(3)

 

PRESSURE

 

 

REDUCING INLETCOLD

 

VALVEWITH

WATER

(,)

BY-PASS

SHUTOFF

EXPANSION

PRESSUREGAUGE

ALTERNATE RECOMMENDED

INSTALLATION

(HORIZONTAL MOUNTING)

STRANGE SOUNDS

Possible noises due to expansion and contraction of some metal

parts during periods of heat-up and cool-down do not represent harmful or dangerous conditions.

Do not remove the anode leaving the tank unprotected. By doing so, all warranty on the water heater tank is voided.

"AIR" IN HOT WATER FAUCETS

AWARNING

HYDROGEN GAS: Hydrogen gas can be produced in a hot water system that has not been used for a long period of time (generally two weeks or more). Hydrogen gas is extremely flammable and explosive. To prevent the possibility of injury under these conditions, we recommend the hot water faucet be opened for several minutes at the kitchen sink before any electrical appliances which are connected to the hot water sys- tem are used (such as a dishwasher or washing machine). If hydrogen gas is present, there will probably be an unusual sound similar to air escaping through the pipe as the hot water faucet is opened. There must be no smoking or open flame near the faucet at the time it is open.

Condensation causes sizzling and popping with the burner area

during beating and coolln{_ periods and should be considered normal. See Condensation section.

23

Page 23
Image 23
Kenmore 153.330402, 153.330502, 153.330752, 153.330552 Troubleshooting Guide contd, Strange Sounds, AIR in HOT Water Faucets