Kenmore 153.331413 HA, 153.331514 HA, 153.331543 owner manual Temperature Regulation

Models: 153.331413 HA 153.331514 HA 153.331543

1 28
Download 28 pages 62.09 Kb
Page 19
Image 19
Temperature Regulation

Temperature Regulation

Due to the nature of the typical gas water heater, the water temperature in certain situations may vary up to 3OF° (16.7 C°) higher or lower at the point of use such as, bathtubs, showers, sink, etc.

Any water heater's intended purpose is to heat water. Hot water is needed for cleansing, cleaning, and sanitizing (bodies, dishes, clothing). Untempered hot water can present a scald hazard. Depending on the time element, and the people involved (adults, children, elderly, infirm, etc.) scalding may occur at different temperatures.

Water temperature over 125°F (52°C) can cause severe burns

instantly resulting in severe injury or death.

Children, the elderly, and the physically or mentally disabled are at highest risk for scald injury,

Feel water before bathing or showering.

Temperature limiting valves are available.

Read instruction manual for safe temperature setting.

HOTTER WATER CAN SCALD: Water heaters are intended to produce hot water. Water heated to a temperature which will satisfy space heating, clothes washing, dish washing, and other sanitizing needs can scald and permanently injure you upon contact. Some people are more likely to be permanently injured by hot water than others. These include the elderly,

children, the infirm, or physically/mentally handicapped. If anyone using hot water in your home fits into one of these groups or if there is a local code or state law requiring a certain temperature water at the hot water tap, then you must take special precautions. In addition to using the lowest possible temperature setting that satisfies your hot water needs, a means such as a mixing valve, shall be used at the hot water taps used by these people or at the water heater. Mixing valves

are available at plumbing supply or hardware stores. Follow manufacturer's instructions for installation of the valves. Before

changing the factory setting on the thermostat, read the

Temperature Regulation section in this manual. See Figures 21 and 22.

Never allow small children to use a hot water tap, or to draw

their own bath water. Never leave a child or handicapped person unattended in a bathtub or shower.

NOTE: A water temperature range of 120°F-140°F (49°C-60°C) is recommended by most dishwasher manufacturers.

The thermostat of this water heater has been factory set at its lowest position (PILOT LIGHTING). It is adjustable and must be reset to the desired temperature setting to reduce the risk of scald injury. The mark (A) indicative of approximately 120°F (49°C) is preferred starting point. Some states have a requirement for a lower setting.

Turn the water temperature dial clockwise ( _ ) to decrease the temperature, or counterclockwise (('_) to increase the temperature.

Should overheating occur or the gas supply fail to shut off, tum off the manual gas control valve to the appliance.

GAS CONTROL KNOB

IGNITER

GENERATOR

PIEZO

THERMOSTAT

DIAL

RGURE21,

VERY HOT= approx. 160°F(71°C)

About

1/2

second

 

 

 

 

 

C = approx.

150°F (66°C)

About

 

1-1/2

seconds

B = approx.

140°F (60°C)

Less

than

5

seconds

 

 

 

 

 

A = approx.

130°F (54°C)

About

30

seconds

• = approx.

120°F

(49°C)

More

than

5 minutes

LOW = approx. 80°F

(27°C)

 

 

 

 

 

RGURE22,

19

Page 19
Image 19
Kenmore 153.331413 HA, 153.331514 HA, 153.331543 owner manual Temperature Regulation