Kenmore 153.33453, 153.33443 A. Tools required, For these instructions, please see Figure

SERVICE INSTRUCTIONS FOR GAS CONTROL VALVE ASSEMBLY

A. Tools required:

1.T15 Torx Screwdriver

2.3/16” slotted screwdriver.

3.Open-end wrenches 7/16”, and 3/4”.

For these instructions, please see Figure 28.

B. Removing Electronic Control Module:

1.Turn the gas control/temperature knob to the “OFF” position.

2.Turn off the gas at the manual shut-off valve on the gas supply line.

3.Disconnect the wire connectors from the piezo igniter, tank sensors, and thermopile mounted on the lower front of the gas control valve assembly.

4.Remove the torx screw located beside the pilot tube on the lower front of the electronic control module with a T15 torx screwdriver.

5.Depress the two plastic locking tabs on the top surface of the electronic control module with a 3/16” slotted screwdriver.

6.Grasp the sides of the electronic control module and pull outward to remove.

C. Removing Gas Valve Assembly:

1.Follow steps 1 to 6 in B above to remove the electronic control module.

2.Disconnect the inlet gas supply to the gas valve.

3.Loosen the fl are nut that connects the pilot tube to the bottom of the gas control valve assembly with a 7/16” open-end wrench. Pull down on the pilot tube to separate the tube from the gas valve.

4.Loosen the flange nut that connects the burner tube to bottom of gas control valve with a 3/4” open-end wrench. Pull down on the burner tube to separate the tube from the gas valve.

5.Remove the torx screw located beside the pilot tube on the lower front of the gas valve assembly with a T15 torx screwdriver.

6.Depress the two plastic locking tabs on lower front surface of gas valve with a 3/16” slotted screwdriver.

7.Grasp the sides of the gas valve and pull outward to remove.

D. Removing Gas Valve Backplate (If Snap-on Design):

1.Follow steps 1 to 7 in C above to remove the gas valve assembly.

2.Pull forward or break off the two plastic locking tabs using a 3/16” slotted screwdriver.

3.Grasp the sides of the back-plate and slide upward to remove it from the gas valve nipple.

4.Unscrew and remove the gas valve nipple by turning it to the left.

5.Follow steps 1 and 2 in F below to install the new gas valve assembly.

E: Removing Gas Valve Backplate (If Screw-in Design):

1.Follow steps 1 to 7 in C above to remove the gas valve assembly.

2.Unscrew and remove the backplate by turning it to the left until it separates from the backplate nipple.

3.Install new backplate and check for leaks.

F: Installing Gas Valve Assembly:

1.Install the new gas valve (with nipple) onto the tank and tighten securely to ensure no leaks.

2.Reconnect the burner tube, pilot tube, and inlet gas supply line to the gas valve. Tighten securely and check for gas leaks.

G: Installing Electronic Control Module:

1.Align the two plastic locking tabs on the top surface of the electronic control module with the openings of the gas valve back-plate. Press on the front of the control module until it locks into position.

2.Reinstall the torx screw on the lower front of the electronic control module (beside pilot tube) with a T15 torx screwdriver. Tighten securely.

3.Reconnect the wire connectors from the piezo igniter, tank sensors, and thermopile to the electronic control module.

4.Light the heater following the lighting and operating instructions on the front surface of the heater.

26