Kenmore 153.337072, 153.337002 owner manual Facts to Consider About Location, Acaution

Models: 153.337002 153.337072

1 32
Download 32 pages 32.44 Kb
Page 10
Image 10

Installation Instructions (cont'd)

Facts to Consider About the

Location

You should carefully choose an indoor location for the new water heater, because the placement is a very important consid- eration for the safety of the occupants in the building and for

the most economical use of the appliance. This water heater is not for use in mobile homes or outdoor installation.

Whether replacing an old water heater or putting the water

heater in a new location, the following critical points must be observed.

The location selected should be indoors as close as practical to the gas vent or chimney to which the water heater vent is going to be connected, and as centralized with the water pip- ing system as possible. The water heater, as all water heaters, will eventually leak. Do not install without adequate drainage provisions where water flow will cause damage.

ACAUTION

WATER HEATERS EVENTUALLY LEAK: Installation of the

water heater must be accomplished in such a manner that if the tank or any connecti_'nsshould leak, the flow of water will not cause damage to the structure. For this reason, it is not advisable to install the water heater in an attic or upper floor When such locations cannot be avoided, a suitable drain pan shouldbe installed under the water heater. Drain pans are avail. able at your local Sears store. Such a drain pan must be not greater than 1¼ inchesdeep, have a minimum length and width of at least 2 inches greater than the water heater dimensions

and must be piped to an adequate drain. The pan must not restrict combustion air flow. Under no circumstances is the

manufacturer or Sears to be held liable for any water damage in connection with this water heater.

AWARNING

INSTALLATIONS IN AREASWHERE FLAMMABLELIQUIDS VAPORS) ARE LIKELY TO BE PRESENT OR STORED

GARAGES, STORAGE, AND UTILITY AREAS, ETC): Flammableliquids(suchas gasoline,solvents,propane(LP) or butane, etc.), all of which emit flammable vapors, may be improperlystoredor usedin suchareas.The gaswater heater

pilot light or main burnercanignite suchvapors.The resulting flashbackandfire cancausedeathor seriousburnsto anyonem

the area,aswellaspropertydamage.

If installationin suchareasisyour onlyoption,then the installa-

tion must be accomplishedin a way that the pilot flame and mainburnerflameare elevatedfrom the floor at least 18inches.

While this may reduce the chancesofflammablevaporsfrom a floor spillbeingignited,gasolineand otherflammablesubstances shouldneverbe storedor usedin the same room or area con-

taininga gaswater heateror other openflameor sparkproduc- ingappliance.

NOTE: Flammablevaporsmay be drawnby air currentsfrom i otherareasofthe structureto the appliance.

AWARNING

The location selection must provide adequate clearances for ser- vicing and proper operation of the water heater.

AWARNING

This water heater must not be installed directly on carpeting. Carpeting must be protected by a metal or wood panel beneath the appliance extending beyond the full width and depth of the appliance by at least 3 inches (76.2mm) in an) direction, or if the appliance is installed in an alcove or closet the entire floor must be covered by the panel. Failure to heec this warning may result in a fire hazard.

AWARNING

Minimum clearances between the water heater and com- bustible construction are I" at the sides and rear, 4" at the

front, and 6" from the vent pipe. Clearance from the top of the jacket is 18" on most model_ Note that a lesser dimension may be allowed on some models. Refer to the label on the water

heater adjacent to the gascontrol valve for all clearances.

AWARNING

Agaswater heater cannotoperate properlywithout the cor- rect amount of air for combustionDo. not installin a confined

area sucha closet,unlessyou provideair asshownin the "Facts to Cc_nsiderAbout the Location"section.Never obstructthe

flowof ventilationair If youhaveany doubtsor questionsat all, callyour gascompanyFailureto. providethe properamount of combustionair canresult in a fire or explosionand cancause

DEATH, SERIOUSBODILYINJUly, OR PROPERTYDAMAGE.

AWARNING

If this water heater willbe usedin beautyshops,barber shops, cleaning establishments,or self-servicelaundrieswith dry cleaningequipment,it is imperativethat the water heater or water heatersbe installedso that combustionand ventilation air be taken from outsidethese areas. Referto the "Facts to ConsiderAbout the Location"sectionof this manual and also the latesteditionofthe NationalFuelGasCode, ANSI Z223.1, also referred to as NFPA 54 for specificsprovidedconcerning

air required.

Propellantsof aerosolspraysand volatile compounds,(clean- ers, chlorinebasedchemicals,refrigerants,etc.) in addition to beinghighlyflammablein manycases,will alsochangeto cor-

Figure I I

CLOSET INSTALLATION

(ACCEPTABLE)

rosive hydrochloricacid when exposedto the combustion productsof the water heater.The results can be hazardous, and also causeproductfailure.

A closet is any 4 sided enclosure which is less than 16' times the total volume of all the gas fired appliances within the enclosure.

10

Page 10
Image 10
Kenmore 153.337072, 153.337002 owner manual Facts to Consider About Location, Acaution

153.337002, 153.337072 specifications

The Kenmore 153.337072 and 153.337002 represent a duo of high-efficiency window air conditioning units that have become popular choices for consumers seeking effective cooling solutions. Engineered with modern technology, these models promise to deliver optimal performance while maintaining energy efficiency.

One of the standout features of the Kenmore 153.337072 is its dual cooling and heating functionality. This versatility allows it to not only cool spaces during the hot summer months but also provide warmth during the chillier seasons. With a cooling capacity of 7,000 BTUs, it is suitable for rooms up to 350 square feet, making it ideal for bedrooms or small living areas. On the other hand, the 153.337002, while also a cooling unit, focuses solely on cooling performance, boasting a similar BTU capacity tailored for energy-efficient cooling.

Both models incorporate advanced energy-saving technologies. They are equipped with Energy Efficiency Ratio (EER) ratings that exceed the minimum standards set by energy regulatory bodies. This means consumers can enjoy a comfortable indoor climate without incurring high electricity bills. With features like programmable timers and sleep modes, users can manage cooling more effectively, adjusting temperature settings to minimize energy consumption.

In terms of user convenience, both units come with user-friendly remote controls, allowing easy adjustments from anywhere in the room. The digital control panel is intuitive, featuring clear LCD displays for monitoring settings. They also include multiple fan speeds and cooling modes to cater to individual preferences, ensuring a personalized experience.

Maintenance is simplified with the inclusion of washable and reusable air filters, which enhance indoor air quality by reducing dust and allergens. A filter replacement indicator alerts users when a cleaning is required, promoting optimal performance and hygiene.

In conclusion, the Kenmore 153.337072 and 153.337002 embody a blend of efficiency, user convenience, and advanced cooling technology. Whether you are looking for a unit that provides both heating and cooling or one focused solely on cooling, these models offer reliable solutions to keep indoor spaces comfortable year-round. Their commitment to energy efficiency not only benefits consumers economically but also aligns with environmentally conscious practices, making them a noteworthy choice in the air conditioning market.