@7 _ | _ _, i | _:_, |
Rotary Controls Ion some models)
For your convenience, your refrigerator controls are preset at the
factory. When installing your refrigerator, make sure that the
controls are still preset to the
FREEZERREFRIGERATOR
!I
2 |
|
|
| 4 |
|
COLD | COLDER | COLD | 1 | 6 | COLDER |
IMPORTANT:
•Your product will not cool when the REFRIGERATOR Control is set to OFF.
•The Refrigerator Control adjusts the refrigerator compartment temperature. The Freezer Control adjusts the freezer compartment temperature. Settings to the left of the mid- setting make the temperature less cold. Settings to the right of the
•Wait 24 hours before you put food into the refrigerator. If you add food before the refrigerator has cooled completely, your food may spoil.
NOTE: Adjusting the Refrigerator and Freezer Controls to a higher (colder) setting will not cool the compartments any faster.
The preset settings should be correct for normal household usage. The controls are set correctly when milk or juice is as cold as you like and when ice cream is firm.
If the temperature is too warm or too cold in the refrigerator or freezer, first check the air vents to be sure they are not blocked before adjusting the controls.
Adjusting Rotary Controls
If you need to adjust temperatures, adjust the refrigerator temperature first.
NOTE: Wait at least 24 hours between adjustments and then re- check the temperatures.
sw sd | , ,nse rs |
(o_ some _nod_,,;¢4
Cut Hazard
Use a sturdy glass when dispensing ice or water. Failure to do so can result in cuts,
Depending on your model, you may have one or more of the following options: the ability to select either crushed or cubed ice, a special light that turns on when you use the dispenser, or a lock option to avoid accidental dispensing.
The ice dispenser
Ice dispenses from the ice maker storage bin in the freezer. When the dispenser lever is pressed:
•A trap door opens in a chute between the dispenser and the ice bin. Ice moves from the bin and falls through the chute.
•When you release the dispenser lever, the trap door closes and the ice dispensing stops. The dispensing system will not operate when the freezer door is open.
Some models dispense both cubed and crushed ice. Before dispensing ice, select which type of ice you prefer. The button controls are designed for easy use and cleaning.
•For cubed ice, press the CUBE button until the red indicator appears in the window above the CUBE button.
ICE
CONDITION/REASON:
REFRIGERATOR too cold
Not set correctly for your conditions
REFRIGERATOR too warm
Door opened often, large amount of food added or room temperature very warm
FREEZER too cold
Not set correctly for your conditions
SETTING
ADJUSTMENT:
REFRIGERATOR
Control one setting lower
REFRIGERATOR Control one setting higher
FREEZER Control one setting lower
•For crushed ice, press the CRUSH button until the red indicator appears in the window above the CRUSH button.
For crushed ice, cubes are crushed before being dispensed. This may cause a slight delay when dispensing crushed ice. Noise from the ice crusher is normal, and pieces of ice may vary in size. When changing from CRUSH to CUBE, a few ounces of crushed ice will be dispensed along with the first cubes.
To dispense ice:
1.Press button for the desired type of ice.
2.Press a sturdy glass against the ice dispenser lever. Hold the glass close to the dispenser opening so ice does not fall outside of the glass.
FREEZER too warm/too | little ice | FREEZER Control one |
Door opened often, or large amount | setting higher | |
| ||
of food added or very cold room |
| |
temperature (can't cycle | often |
|
enough) or heavy ice usage
IMPORTANT: You do not need to apply a lot of pressure to the lever in order to activate the ice dispenser. Pressing hard will not make the ice dispense faster or in greater quantities.
10
