The water dispenser will not operate properly
Has the water system not filled? The water system needs to be filled the first time it is used. Use a sturdy container to depress the water dispenser bar until the water begins to flow. Flush the water system by dispensing and discarding
2 to 3 gal. (8 to 12 L) of water. Cleaning the system will take approximately 6 to 7 minutes and will help clear air from the line. Additional flushing may be required in some households. See the "Water and Ice Dispensers" section.
Is the water shutoff valve not turned on or the water line connected at the source? Make sure the water shutoff valve is turned on and the water source is connected to the refrigerator. See the "Water Supply Connection" section.
Is the water shutoff valve clogged or incorrectly installed?
See the "Water Supply Connection" section. If clogging or installation is not a problem, call for service or contact a plumber.
Is there a kink in the home water source line? If you find or suspect a kink in the water line, call for service.
Is there a water filter installed on the refrigerator?. The filter may be clogged or incorrectly installed. First, check the filter installation instructions to ensure that the filter was installed correctly and is not clogged. If installation or clogging is not a problem, call for service.
Water or ice is leaking from the dispenser
Is the glass not being held under the ice dispenser long enough, causing the ice to spill? Hold the container under the ice chute for two to three seconds after releasing the
dispenser lever. Water or ice may continue to dispense during this time.
Is an ice cube stuck in the chute and holding the trap door open? Remove the cube.
Is there a water filter installed on the refrigerator?. The
water filtration system may have air in the lines, causing water to drip. Additional flushing may help clear air from the lines. Normal dispenser use should flush air from the lines within 24 to 72 hours.
Water flow from the dispenser decreases noticeably
•Is there a water filter installed on the refrigerator?. The filter may be full or incorrectly installed. Remove the
water filter cartridge (see the "Water Filtration System" section). Operate the dispenser. If the water flow increases noticeably, replace the filter.
The dispenser water is not cool enough
•Has the refrigerator been newly installed? Allow 24 hours for the refrigerator to cool completely.
•Has a large amount of water been recently dispensed? Allow 24 hours for the water to cool completely.
•Has water not been recently dispensed? The first glass of water may not be cool. Discard the first glass of water.
The divider between the two compartments is warm
The warmth is probably due to normal operation of the automatic exterior moisture control. If still concerned, call for service.
Temperature is too warm
Are the air vents blocked in either compartment? This prevents the movement of cold air from the freezer to the refrigerator. Remove any objects from in front of the air vents. See the "Ensuring Proper Air Circulation" section for the location of air vents.
•Are the door(s) opened often? The refrigerator will warm when this occurs. Keep the refrigerator cool by getting all items out at one time, keeping food organized, and closing the door as soon as possible.
•Has a large amount of food just been added to the refrigerator or freezer?. Adding a large amount of food warms the refrigerator. It can take several hours for the refrigerator to return to the normal temperature.
•Are the controls set correctly for the surrounding conditions? See the "Setting or Using the Controls" section.
•Is the refrigerator not cooling? For models with digital controls, turn the unit OFF then ON again to reset. See the "Setting or Using the Controls" section. If this does not correct the problem, call for service.
There is interior moisture buildup
Are the air vents blocked in the refrigerator? Remove any
objects from in front of the air vents. See the "Ensuring Proper Air Circulation" section for the location of air vents.
Are the door(s) opened often? Avoid humidity buildup by
getting all items out at one time, keeping food organized, and closing the door as soon as possible.
Is the room humid? It is normal for moisture to build up inside the refrigerator when the room air is humid.
Is the food packaged correctly? Check that all food is
securely wrapped. Wipe off damp food containers before placing in the refrigerator.
Are the controls set correctly for the surrounding conditions? See the "Setting or Using the Controls" section.
Was a
The doors will not close completely
Are food packages blocking the door open? Rearrange containers so that they fit more tightly and take up less
space.
Is the ice bin or ice bucket out of position? For models with an interior ice bin, push the ice bin in all the way. If the ice bin does not go in all the way, it may not be put in straight. Pull it out and try again. For models with an ice bucket located on the freezer door, the bucket should sit level. To
remove the bucket, press the release button on the right side of the bucket and lift straight up. Replace the bucket in the
door making sure it is properly aligned and snapped securely
into place. See the "Ice Maker and Storage Bin/Bucket" section.
Are the pans, shelves, bins, or baskets out of position?
Put the crisper cover and all pans, shelves, bins, and baskets
back into their correct positions. See the "Crisper and Crisper Covers" section for more information.
Are the gaskets sticking? Clean gaskets according to the directions in the "Cleaning" section.
19
