Kenmore 233.5998811, 233.5998892 Niring Diagram, Cleaning, Service Parts, Light Bulb Replacement

Cleaning

i

WARNINGi

ALWAYS DISCONNECT ELECTRIC POWER SUPPLy I BEFORE SERVICING HOOD.

Use a mild detergent suitable for painted surfaces. DO NOT USE

SERVICE PARTS

Kenmore Range Hood - Model 233.5998892 Black

Model 233.5998811 White

ABRASIVE CLOTH, STEEL WOOL PADS, OR SCOURING POWDERS. Vacuum blower to clean. Do not immerse blower in

water.

Wash the foam filter in a mild detergent solution.

The glass drawer assembly and light tens are easily removable for cleaning:

See Step 13 on page 4 for removal of glass drawer assembly. DO NOT clean in a dishwasher.

Remove the light lens by opening the filter panel (Step 6, page 2) and rotating the 2 metal clips holding the lens in place.

Light Bulb Replacement

Your hood uses a 24" long F20T12 fluorescent tube and an FS-2 starter, which are available at most hardware stores or home ;enters.

To check or replace tube: 1) Pull drawer out. 2) Rotate filter panel _.lips and lower filter panel.

If the tube flickers or does not light, check the prongs on the ends

_f the tube to make sure they are properly seated in the tube qolders,

f the tube continues to flicker or does not light, replace the tube. Slide the tube into the holders and rotate the tube so that the _rongs in the holders grip the tube and hold it in place.

f the ends of the tube light but the center does not, the starter 'nayrequire replacement. The starter is located behind the filter )anel on the right hand side. !nstall the new starter by pushing he starter in and turning it clockwise.

f the tube still does not light, order a 99270651 Ballast Trans- ormer available through Sears stores.

NIRING DIAGRAM

KEY	BLACK	WRITE
NO.	PART NO,	PART NO.
1	98OO694O	96007168
2	99156538	99150478
3	99090677	99690697
4	993001_	99360140
5	99170245	99170245
6	97006078	97006078
7	980057_21	98005221
8	99100379	99100379
9	97008644	9700_981
	97008641	97008982
10	93260454	93260454
11	97011874	97011873
12	97008578	97008578
13	97008618	97008618
14	99160344	99100344
15	99150538	99150538
	99100537	99150537
16	970O8594	97008594
17	99230345	99230342
18	99160319	99160319
19	98005860	98005860
20	99270500	99279950
21	99270651	99270651
22	99270553	99270553
23	97998619	97008619
24	99400042	99400042
25	98006937	98007164
26	98006938	98006938
27	99100463	991(30463
28	97008971	97008979
	97008970	97008978
29	99250932	9925_32
30	97009057	97009117
31	99110683	99110699
32	99420508	99420514
33	98007155	98007155
34	90020139	99920139
35	98005212	980_212
36	99100491	99100491
37	99080359	99080359
38	99260476	99260476
39	99420464	99420464
40	97007314	97007314
41	99020138	99020138
42	99140156	99148156
43	99010175	99010175
44	97011138	97011139
46	90050018	99050018
48	99150492	99150492
49	99100408	991OO464
50	99150471	99150471
..	97008628	97008628
	97005985	97005985
	99041399	99041399

DESCRIPTION

FrontTrim

Screw#8-18x 3/8 (14 Required)"

ControtTrim

ControlKnob

Screw #6-18x 3/8 (8 Required)"

Damper Assembly (Includes Key NOS.

7& 5)

Damper F{ap

Damper Bushing

RH Mounting Bracket (Includes Key No. 10)

LH MountingBracket(includesKeyNo. 10) #8 SheetMetal Nut "U'"Type

(11 Required)

Canopy

Control Board

Control Harness

Screw#8-32 x 3/16 (5 Required)"

Screw #8-18x 2 (4 Requited)"

Screw #8-18 x 1 [4 Required)"

Switch Assembly

Rivet (13 Requited)

Screw #6-32x 3/8 (4 Required)"

LampholderBraskel (2 Required)

Lamphotder(2 Required)

BallastTransformer

Starter FS-2"

Light Harness

Strain ReliefBushing SR-4N-4 (2 Required

Access Cover

Wire Box Cover

Drawer Stop (2 Required)

LH Drawer BraoketAssembly(Includes Ke,,

Nos. 32 & 33)

RH DrawerBracket Assembly(Includes

Key Nos. 32 & 33)

Washer (2 Required)"

Drawer Assembly (Includes Key Nos.14 & 31)

Drawer End Cap

Thumb Screw (4 Required)

Drawer Clamp (2 Required)

BlowerWheel, COunlerclockwise

MotorRetainingRing (2 Required)

RubberMotorMount(4 Required)

Motor

Blower Mounting Rod Nut(2 Required)

Blower Mounting Rod (2 Required)

BlowerScroll Housing

Blower Wheel, Clockwise

Fitter Spring(2 Required)

FilterFoam

FilterPanel

LightLens

Screw#8-18x V_(2 Required)'

Plastic Cap (4 Required)

Screw #10-32x V2Green (2 Required) Green Wire Assembly

Complete Blower Assembly (Includes Key

Nos 5, 34, 35, 36, 37, 40,41)

Fluorescent Light Tube F20T12" (Not Included)

Instruction Book

*Standard Hardv_are. May be purchased locally

•"NOt Illustrated.