Door Removal instructions
Top Hinge
Top Hinge
Eye Brow
Cable
| Bottom |
| Hinge |
Tube | _' |
| Cable Bracket |
| Block |
| /Pin |
| Center |
| Hinge |
Tools Necessary:
3/8"
Fixed
Wrench
_nc]
Head |
| |
Screw | Driver | Sockel |
|
| Wrench Sel |
DOOR REMOVAL iNSTRUCTiONS:
If your refrigerator will not fit through an entrance area. you can _educe its size by removing the doors. Checkfirst by measunng the entrance.
IMPORTANT: Before you begin turn the refrigerator temperature control to "0" and remove the electrical power cord from the wall outlet. Remove food from door shelves.
1.Disconnect electrical supply.
2.Remove toe grille (see figure on page 5). To remove freezer door:
1. Remove top hinge cover, eye brow and screws.
2.Trace around the hinge with a soft lead pencil. This makes reinstallation easier.
3.Remove top hinge and lift door off bottom hinge pin.
4.Reinstall doorin opposite orderand mannerof removal.
To remove refrigerator door:
1.Place wood block under door to support itsweight.
2.Unfasten the
3.Detach the
Place your thumbs on flat sides of each connector, grasp firmly, and pull apart.
4.Detach the water tube from the connector located below the door. The connector releases when you press its outer sleeve inward.
NOTE: If refrigerator has been used, have a container ready to catch excess water from tube.
5.Remove the bottom hinge screws and hinge, holding the door as its weight rests on the wood block. Lay the door on its side to avoid damage to cable and tube.
6.Remove the center hinge screws and hinge. Ensure plastic washer stays on hinge pin.
7.Reinstall door in opposite order and manner of removal. When both doors are reinstalled, connect water line by inserting tube and pushing until mark touches face of fitting. Connect cable, replace toe grille, and plug in electrical power cord.
ToD,sCo."EcT
1. Press outer ring against face
i
_ 2. Pullto remove tube
Insert tube and
pUSh Until mark touches _ace of fitting
