Kenmore 35132 manual Compressor does not activate, The unit deactivates, Error Codes

		areas). Run the unit for ½ a day. The smell
		will disappear after a while. In the case of
		intensive odor development air the room.
Compressor does not activate		∙ Depending on ambient temperatures and
		unit type it may take approx. 10 minutes
		after starting the compressor until the
		cooling/heating capacity is reached.
The unit deactivates		∙ On reaching the set required temperature,
		the unit switches off automatically. Check
		manual setting of the required temperature
		as well as the TIMER setting.
The unit does not cool correctly		∙ You achieve the most effective and
		economical cooling comfort if you already
		cool the room to be cooled when the room
		temperature is not yet heated up. Air
		conditioners operate more effectively if the
		temperature is maintained. To drastically
		cool the air in a fully heated room requires
		much more time and energy.
ERROR CODES
E1	∙ Room temperature outside the	∙ Observe all data in these operating
	function range:	instructions concerning function range.
		Temporary error of start temperature.
	∙ Room temperature inside the	Please switch the unit off and start it again
	function range:	after approx. 30 minutes. If the error
		occurs continuously, the unit requires
		qualified inspection.
E2	∙ Temperature of the cooling	∙ Temporary error on measuring output
	agent lines too high or too low	temperature. Please switch the
		TRANSFORM unit off and start it again
		after approx. 30 minutes. If the error
		occurs continuously, the unit requires
		qualified inspection.
E3	∙ Incorrect signal	∙ This error message in the cooling function
		refers to too high ambient temperatures
		and in the heating function to too low
		ambient temperatures. Please observe the
		instructions relating to ideal operation of
		the unit. This may also be a temporary
		error measurement between the start and
		output temperature. Please switch the unit
		off and start it again after approx. 30
		minutes. If the error occurs continuously, the
		unit requires qualified inspection.
E4	∙ Water tank full	∙ If the water tank is full, the warning sign
		"E4" appears in the display. To restart
		operation of the unit, please remove the
		plug of the condensation water outlet to
		allow water to leak out. Please use an
		appropriate collection tank. When the
		water has been completely removed,
		please start the unit again. The unit can
		now be used as usual.
DF	∙ De-icing mode	∙ This procedure is completely normal and
		protects the system from icing and failure.
		The unit starts automatically after approx.
		15 minutes again (depending on the
		function setting). This procedure repeats
		itself regularly.

15