,CONNECT THE TUBING TO THE

REFRIGERATOR

Removing and Replacing Valve Cover

NOTE:

Before making the connection to the refrigerator, be

sure the refrigerator power cord is not plugged into the wall outlet.

1. Loosen screw on top of plastic cover.

2. Lift off the cover by slightly pushing up.

4.Insert the tube into the valve and fasten with wrench as shown in the figure below.

Tubing

ACAUTION: Check to see if water dripping occurs at water line connections.

5.Bend the tube upwards and fasten it into the clamp provided to hold it in position. Replace the cover and tighten the cover screw.

Tubing

Clamp

3.Place a compression nut and a ferrule(sleeve) onto the end of tubing.

Compression Nut

(

-_

Ferrule (sleeve)

29

Page 29
Image 29
Kenmore 79575559400, 3840JL2019A manual Connect the Tubing to, Refrigerator